The blower motor is tired. It will eventually blow a fuse and/or burn out the blower motor speed resistor. Time to replace the blower motor. Also check connections for high resistance damage (melted connections).
Either it's losing voltage, or you've got a blower motor on its way out.
The blower motor speed resistor is burned out. The resistor is usually found close to the blower motor. Auto parts stores carry that part and it is easy to replace.
Possibly. A bad blower motor resistor would cause the blower motor to either not function or function only on one speed (usually high speed). The air conditioning system is probably set up such that if the blower isn't functioning at all, the air conditioner won't function. Otherwise the air conditioner would overheat.
A malfunctioning blower motor resistor will cause the blower motor not to work. When the resistor is bad the blower motors will not turn on.
Most likely cause is a failed blower resistor.
neither,blower resistor or blower module controls fan speeds.
Check the fuses first and the blower relay.
Blower motor NG. Blower motor resister NG. Blower motor fuse NG. Blower motor switch NG.
most likely cause is one of three relays for the blower motor, usually located on the firewall under a plastic covering or near the battery If you do not use the blower motor very often like your car sits for a few weeks mositure gets in the blower motor and causes rusting which can cause your blower motor to lock up. Best suggestion is to run you air conditioning unit on high for about half an hour every once in a while.
The following can cause this problem.................. 1. Bad blower motor. 2. Bad blower motor wheel. 3. Trash in the blower housing...
Usually it will only allow you to travel to and from work. Or if your occupation consists of driving, youll only be allowed to drive for work. People who lose their license usually get this if them not driving will cause hardship on the family.
If the blower runs on high it will get hot. If the blower is wearing out this will cause it to get to hot and blow.
A common cause for this is a burned out blower resistor. Tech JK --------------------------