answersLogoWhite

0


Best Answer

chk. compression,150 is normal,about 120 or less in no. 6 and it will miss at idle,but you wont feel it under a load.

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What would cause no.6 misfire i replaced plug wire fuel injector still has miss at idle?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you fix a diesel cylinder misfire?

1: Replace the injector. 2: If still misfiring, replace the engine.


What is the cause of a misfire on cylinder 3 in a 2002 buick rendezvouz?

a tune up will fix that If plugs and wires do not fix you may want coil tested if still not fixed look at injector


We replaced every sensor on your 1994 s10 and the truck still has a bad miss in it?

Bad spark plug wires or spark plugs can cause your 1994 Chevrolet S 10 two misfire. A plugged fuel filter can also cause the vehicle to misfire.


Susuki vitara P0304 code misfire 4 cylinder replaced plugs still misfires?

this could be caused by a fuel problem, not spark. check to see if your getting spark to the plug. ck to see if the injector is firing, and run a compression test on that cylinder


1998 dodge misfire replaced plugsinjectordist cap and rotor still misfire?

check wire routing,order, or if replace is needed, after that check compression, head gasket,or crack in head.


My 98 Grand Prix GTP has a 1 and 3 misfire I've replaced plugs wires coil compression tested it and it still misses on 1 and 3 if i unplug the 1 injector wire it still runs the same no worse thanks?

Check out the following website for a outline of what to look for when encountering this problem: http://www.oqcgp.com/forum/kb.php?mode=article&k=59 Hope this helps. "G"


Free mechanic advice w out signing in?

I have a 02 focus with a p0303 code. It is a misfire on cyl 3. I have replaced the plus and the plug wires and i still have the problem.


After installing new ignition module and coil pack it still misses?

Assuming the plugs and wires have already been replaced you may have a bad fuel injector.


What could make 97 Chevy lumina 3.1 v-6 misfire on 3 cylinder replaced spark plugs and wires still missing?

you might check the coilpak


What would be wrong with a 92 tracker pumping way too much fuel through the injector I replaced the injector-ecm-fuelpump relays-and pressure regulator and yet it still dumps excess fueL AT injeCTOR?

i would check the wires, you might have a short to power which would keep the injectors open all the time.


What does it mean when you change plugs and wires run two bottles lucas fuel injector cleaner through system and still have multiple misfire and power loss on 1999 Monte Carlo?

Probably have a bad ignition coil Which cylinder is not firing?


What could cause a 2001 Ford Focus DOHC with good spark plugs and wires to misfire in cylinder 4 when driving and cause stalling stumbling and P0304 CEL code?

Have you checked the injector? Try switching the plug and/or wire to another cylinder to see if the misfire travels with them. That check engine means cylinder 4 misfire so I would still check the gap and make sure that the spark plug is good even though they are new another suggestion is the coil pack. And a much less likely suggestion is that you lost compression but that's easy to test just take cylinder 4 spark plug out and put a compression gauge in and manually turn the motor over by the crankshaft.