0
What would cause the ballcock to suddenly pop up out of its fixture and water to sputter in the tank if this happened spontaneously and not during use?
Wiki User
∙ 19y ago
A surge in water pressure can cause this. Also, a defective ballcock would pop off under these conditions. Replace the ballcock and consider installing a pressure reducing valve (PRV) on the incoming water line.
Wiki User
∙ 19y ago
Add your answer:
Earn +20 pts
What should you do if your downstairs bathroom continues to run after the toilet is flushed and turning the valve off did not work?
check your pressure regulator valve or house pressure .Replace fixture stop and ballcock assy also r&r flapper
Why 2 bulb fluorescent fixture garage suddenly quit. Both bulbs on I came out garage 30 minutes later lights not working. Checked breaker-outlets-working. Replaced bulbs and fixture still not working?
More than likely the ballast in the fixture has failed.
Who to remove glued-on bathroom light fixture from mirror?
To remove a glued on bathroom light fixture from a mirror, the best product to use is WD-40. Spray on the WD-40 and wait a few minutes while holding up the light fixture so it will not suddenly fall. Gently pull on the light fixture while using a putty knife to scrape the area underneath the lamp next to the mirror. Glue residue can also be cleaned up with the WD-40 after the fixture releases.
Which is a fixture?
what is a sentence for fixture
Is a fan a fixture or furniture?
It would be a fixture.
Is a lock a fitting or a fixture?
A lock is a fixture, same as a light, sink, tub. A fitting is usually a part of a fixture, or a fixture is made up of fittings.
What is the singular possessive of fixture?
The fixture's screws are loose. - singular possessive.The fixtures' screws are all loose. - plural possessive.
Is a fluorescent light grounded?
If you are talking about the lamp then the answer is no. If you are talking about the fluorescent fixture, it should be. It is the fixture grounding that helps the tube to ignite. because of the close proximity to the metal of the fixture. There are many occasions when the fixture will not operate, but as soon as the ground is connected the fixture operates fine.
How do you wire a 220 volts light?
The light is wired the same as any voltage fixture. Bring the source voltage to the fixture and connect it to the two fixture wires. If you want to control the off-on of the fixture take the source voltage to a switch first and then out of the switch to the light fixture.
Is a light bulb considered a fixture?
A fixture is what the light bulb goes into.
What is a pin based fluorescent light fixture?
A pin based fluorescent light fixture is the type of fixture that takes fluorescent tubes. On each end of the fluorescent tubes there are contact pins. These pins are used to hold the tube in the fixture and to supply the voltage to the tube from the fixture's ballast.
What is a key less light fixture?
It just holds the bulb, does not have a switch in the fixture.
