answersLogoWhite

0


Best Answer

Thermostat possibly stuck open. Another possibility is the heater core is clogged. I would recommend you perform a complete cooling system service. Drain and flush the system with the heater set to high. Replace the thermostat, and install a 50/50 mix of coolant and distilled water. Bleed all air from the system.

User Avatar

Wiki User

17y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What would cause the heat in a 1991 Buick Skylark not to get warm?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What size speakers does a 1991 Buick Skylark have?

a 1991 buick skylark has 4" speakers in the dash and 6x9's in back


How do you replace a ignition switch tumbler 1991 skylark?

how do you replace a ignitionswitch tumbler 1991 buick skylark


What would cause a 1991 Buick Skylark to have rough shifting automatic transmitionand then not even start?

Try changeing the fuel filter,I had the same problem and it helped.


Where is the thermostat located on a 1991 Buick Skylark?

The thermostat on a 1991 Buick Skylark is located near the engine. To find the thermostat, follow the top radiator hose directly to the thermostat.


Where does a clutch relay soliniod go in a 1991 b uick skylark goin at?

where does a clutch relay seleniod go in at on a 1991 buick skylark


Is the oil filter in a 1991 Buick Skylark the same as the 1990?

Probably. An auto store would know for sure.


How do tons does a 1991 Buick Skylark weigh?

I'd say about 2.5 tons.


Where is the radiator cap on a 1991 Buick Skylark?

If it has a coolant tank, that's the "cap".


Where is the radiator plug in your 91 Buick Skylark?

You can find the 1991 Buick Skylark radiator drain plug on the bottom of the radiator. The radiator drain plug will be in the center of the radiator bottom.


Where is the flasher in the 1991 Buick Skylark?

Under dash with fuses. Very hard to see.


Where is the PCV valve located on a 1991 Buick Skylark?

The PVC valve for a 1991 Skylark should be located on the top of the valve cover. It is a plug in type, twist and pull to remove.


What type of engine does a 1991 Buick skylark have?

Either a 2.3/2.5 4cylinder or a 3.0 V6