OK, the REAL reason this happened is that the GROUND from the LOW BEAMS opened and did not return to the dash. This causes the HIGH BEAM indicator to not work (because believe it or not, they use the low beam filaments as a return for the low beam indicator!), but the high beams to still work OK. Rather than disassemble the whole dash & turn signal assy., I just ran an additional ground wire to the LOW beams (through a switch, so I could disable it if necessary) and it solved the problem. I still don't have the little blue high beam indicator, but you casn tell if they're on or off . . . P.A.
you have a burned out bulb. when r/turn is on go to rear and check to see it is also working. the same for left.
my gas gauge doesnt work and i dont get a warning light when about to run out, mine goes to fuel when its about to run out
my rear left indicator and alarm light doesnt work, hoe do I change the bulb?.
it doesnt. you should get that checked it may be a problem with the relay
fuse
Have the system checked for trouble codes.
have your catalitic checked, it could be cloged.
Car Doesnt Start
he either doesnt like you or he doesnt want to talk to you at the time or he wants to make you jealous.... and its working huh?
Have you checked you are using the right e-mail or password, try uninstalling it and re- installing it maybe you even have a program on your computer which is doesnt like, try trouble shooting or maybe virus scan your computer.
Have you checked the fuse and relay? - They are in the engine compartment above the passenger strut.
This toy doesnt have one. I own 3 of them for my child. I just checked right now.