Heating AC and Engine Cooling
Ford Taurus
Jeep Grand Cherokee Laredo
Ford Windstar LX

What would cause the temp gauge to not work on a 93 Ford Taurus Station Wagon?

454647

Top Answer
User Avatar
Wiki User
2007-02-15 16:49:42
2007-02-15 16:49:42

The first thing that I would check is the wiring and the temp sensor @ the engine. Sorry but I do not know where the sensor is located on the engine. Usually they are not too hard to locate. i would replace temperature sender usual located near front of engine near thermostat housing

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

don't know but my 95 Taurus gauge is dead except after putting some clean burn gas additive in the tank. guage worked a little then went dead again. deposits?

User Avatar

The oil pressure gauge on a 2002 Ford Taurus is located right next to where the battery is, toward the middle of the actual car. The gauge is connected to the front of the engine.

User Avatar

To change the gauge lights on a 1998 Ford Taurus SE, the dash cover has to be removed to access the burned out bulbs. There are screws and clips holding the dash cover on.

User Avatar

The fuel sending unit is sticking, or the wiring to the gauge is loose. These are the two most common causes of an erratic gauge.

User Avatar

either the fuel gauge needs replacing or the fuel gauge sending unit in the fuel tank is stuck

User Avatar

1999 subaru legacy wagon mph gauge works when it wants to what makes the gauge work? Is it a censor, fuse, wire please help

User Avatar

Depends on what info you are seeking. Rossi is owned by Taurus. The Taurus website would be a good starting point.

User Avatar

Yes it will, up to 500kg. Keep an eye on the temp gauge as it could cause overheating on long uphills or under heavier loads.

User Avatar

Maybe the temp gauge works, but there is a separate coolant temperature sensor for the engine control system, which includes the fans. Check it out.

User Avatar

No - they are in 2 totally different systems

User Avatar

In between the radiator and the tire pressure gauge.

User Avatar

A common cause for a gas gauge to stop working in a 1994 Ford Aspire is a defective fuel gauge. Lose wiring in the dash is another cause.

User Avatar

AnswerIt might be the temperature sensor / sending unit.This is actually a pretty easy, and cheap fix. They're usually on the upper right corner of the engine - and just screw-in/out.The folks at the auto parts store should be able to point it out for you on your specific engine.See "Related Questions" below for more

User Avatar

A short in the turn signal wiring can cause the voltage gauge to fluctuate. A loose ground wire can also cause the gauge to fluctuate.

User Avatar

No - See "Related Questions" below for more

User Avatar

I don't know, but you can certainly find a Taurus Judge.

User Avatar

away from houses and in a fenced of area such as a meteorological station

User Avatar

There have been several handguns made that fire .410 shotgun shells- most recently the Taurus Judge. By the way, .410 is actually a caliber of shotgun, not a gauge. A .410 shotshell is about 67 gauge- but no one uses that designation.

User Avatar

You need several pieces of equipment to build a manual weather station. You will need a barometer, thermometer, barograph, hygrometer, rain gauge and humidity station.

User Avatar

Yes, if you get into the trunk or back of the station wagon, you have to find the plate that is held with on phillips screw. Remove that plate, then you will see five 8mm bolts. Remove them and pull the fuel gauge sending unit out enough to get your hose in there. Syphon away.

User Avatar

its proabley the float located inside the gas tank...could be stuck


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.