answersLogoWhite

0


Best Answer

I have had the same problem on my 1996 Blazer. I talked to a bus driver about it and was given this little trick that might help. If it has something to do with brake adjustment, try backing up and slamming on the brakes 4-5 times- sometimes the brakes adjust themselves from us using them in only one direction so much.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What would make the brakes lock up in a 1996 Chevy blazer when going low speeds of 15-30 mph. could they be over adjusted or calipers.?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

When you turn your 1993 Safari at low speeds your van stops like the brakes are on Why?

May be frozen brake calipersMay be rear brakes are not adjusted properlyMay be parking brake cables frozen and are dragging


What happens when the rotors are warped?

Warped brake rotors will cause pulsation (or vibrations at high speeds) when the brakes are applied. This may also go on to misalign the calipers and cause other vibration related damages.


Would having back brakes repaired have anything to do with car stalling when stopping a a stop sign?

Not really, unless they were adjusted too tight but you would have a dragging affect at all speeds and would smell the brakes burning. This is for brake shoes only as pads are not adjustable.


Your Chevy Blazer wobbles at high speeds?

how to change upper tie rod on 96 chevy blazer


New front brake pads and rotors have been installed on a 2001 Toyota and now the brakes jump and or vibrate when applied the problem is when you're braking at speeds over 40.?

There must be either some air in your lines or a weak brake caliper. If you have new rotors and brakes then your problem lies within your lines or your calipers. The vibration means that your car is not braking even. One of your calipers could be loose and the other one is tight. If air is in your lines, then that means even though your car is coming to a stop, your calipers are not getting enough pressure to squeeze as tight as they should be.


1997 senator triple e motor home rear chatter when appling brakes?

last year i had a dealer install new front rotors and pads they also adjusted the rear brakes. after that when stoping or slowing down from freeway speeds the motor home would chatter. since then the have put on new drums and shoes it still chatters .is the adjustment wrong or do i need special shoes.


What can cause vibrations on a truck at high speeds?

I had a similar problem once and it had something to do with my brakes, I'd get them checked if i were you


Have a 98 windstar brakes are making crunching noise in low speeds at higher speeds brakes act normally already checked pads they are brand new any suggestions?

make sure it's not gravel in your front CV joints (driveshafts). are your rubber boots ripped?


What will happen when driving a car if you pull up the brakes?

While assuming your parking/emergency brake is properly adjusted, your car will stop. At higher speeds, say over 50 mph, your car will skid and leave rubber on the road. If you happen to turn your wheels while pulling the emergency brake then you'd do whats called a drift. Bad things can happen to your car if done at high speeds. I would not recommend doing this.


What are the wind speeds of an F1 tornado?

Estimated wind speeds for an F1 tornado on the original Fujita Scale are 73-112 mph. These were found to be inaccurate, though, and were adjusted to 86-110 mph for an EF1 tornado.


1998 ford e150 front end shakes when appling brakes at high rate of speeds?

check the rotors they could be warped


Why is there a rubbing noise as wheels rotate at speeds over 25 mph?

Check your brakes, in most cases the brakes are worn and must be replaced. If not have mechanic do an inspection for anything that is worn ie. bearings, cv axles, bushings