You should treat it as a stop sign. If there is a power outage or malfunctioning light, come to a complete stop at the intersection and yield to cars that stopped before you did.
The Traction Control Light comes on every time you turn on the ignition. It should go off as soon as you start the engine. If it does not, then you have the traction control turned off. Turn it back on and the light will go off. If you have the Traction Control turned on and the light stays lit, then there is a problem with the traction control.
It should turn off when the key is turned to the 'on' position.
It depends on your animal. Do some research and figure out what is best for your pet.
On a 2003 Ford Windstar : The TRAC OFF warning light means that either the traction control system has been turned off by the driver or there has been a problem detected with the system There is a rectangular shaped switch , marked T/C ( I assume it is located somewhere on the dash ) just push the switch again and if the system has been turned off by the driver the light should go off because the traction control system should be turned on now
why the monitor very light
should be on the headlight control, probably turned too far to left, turn slightly right and light should go off
The fridge light should turn off when you close the door. The light is hot because not all the electricity is turned into light - an awful lot is wasted in the form of heat.
The most likely answer is that the parking light switch on top of the steering column is turned on. --Ken The parking light switch is turned off,the engine is turned off,they are still flashing
Overhead light or "Reading Light"
You don't reset the light. The light is on because the Traction Control is turned off. Turn it back on and the light will go off. Look on the shift lever for a button.You don't reset the light. The light is on because the Traction Control is turned off. Turn it back on and the light will go off. Look on the shift lever for a button.
Light should come on for 4 secs and then go off. If it stays on or doesn't come on at all then you have a problem.
Using the proper scanner you can clear the code that turned on the light.But:The the light should go out once the fault is repaired