0
When i try to start my 91 corolla it just clicks i replaced the starter yesterday and it still just clicks yesterday i jumped it and it started right up today i tried to jump it and it still clicks?
Wiki User
∙ 14y ago
i might be wrong but it could be the 'bendex'. this is the part of the starter motor that disengages it after the engine turns on. it might not be fully disengaged from the previous trip. sometimes all that is needed to get it to go is to rock the car foreward or back a little. hope that helps.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Location of starter assembly 1989 Toyota Corolla?
TROUBLESHOTING FOR REPLACED STARTER IN TOYOTA COROLLA 1999.
What is the cost of labor to replace starter in Toyota Corolla?
I live in Austin,Tx and it is costing me $403.16 to have the starter replaced in my 2003 corolla.
Why car don't start after replacing the starter?
Assuming it started before the starter was replaced, the starter and/or starter wiring are not installed correctly.
Starter replacement in a 2003 Toyota Corolla?
how do you change the starter in a 2003 Toyota corolla
Where is the starter relay switch on a 1996 Toyota Corolla?
where is the starter relay switch on a 1996 Toyota corolla
Why will a 2001 grand am not crank it ran fine yesterday and you can hear the fuel pump working?
ur battery or starter needs to be replaced
Where is the starter on a 1996 corolla?
in the trunk
Are the starters in a Toyota Corolla the same as a Toyota matrix?
Starter of toyota corolla and matrix is not the same. The best thing you do if you change your starter by yourself is to remove and compare to the new starter.
Where is the starter located on a 2000 Toyota Corolla?
The starter is located on the front of the engine of the 2000 Toyota Corolla. It is placed on top of the transmission housing.
What is the Size of bolts for 93 geo prizm starter?
Look here: How do you change the starter on a 1996 Toyota Corolla?Prizm and Corolla engines are the same.
How do you connect the positive battery cable to the starter on a 1998 Mazda Protege?
There are two posts on the starter solenoid when the starter is in position the top one is for the positive battery cable. The bottom one should have a very short cable that enters the starter casing. I just replaced the starter in my 98 mazda protege yesterday.
What will damage a starter over and over after the fly wheel was replaced?
If the starter is not properly mounted then it will not properly engage and release the flywheel. The started may need to be shimmed in or out.
