0
When replacing head on an 1987 ford lazer 4 cylinder 1600 turbo four wheel drive where are the timing marks for the cams exhaust and intake for top dead center when putting timing belt on?
Wiki User
∙ 18y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What do you after Replacing distributor on 350 vortec 1998 when the old position was not marked do i need to get tdc again?
Yes!!!! You have to get the engine back to top dead center on cylinder one. Also make sure that it is on the compression stroke and not the exhaust stroke or you will fire 180 out.
Will a 1986 kx125 cylinder fit a 1987 kx125 engin?
No a 1986 Cylinder will not fit the 1987 KX 125. The 1986 exhaust port comes out on the left side of the cylinder where the 1987 comes out in the center. It may bolt up, however the exhaust will not be able to mount.
What valve will be open when the number one cylinder is at top dead center?
Presumably we are talking 4 stroke? If so, none or the exhaust - it will be at the top of the compression or the exhaust stroke
How can you tell which cam is intake or exhaust in a 94 dodge stealth twin turbo?
Real simple exhaust camshafts are the camshafts nearest the exhaust manifolds ( outside if cylinder heads) intake camshafts are on the inside closer to center of engine.
What does ATDC mean?
45 degrees After Top Dead Center.... used in terms for motor cylinder timing...ports (exhaust,transfer,etc)
Which is the exhaust and which is the ignition coil on 1985 Nissan 200sx maunual 2.0 liter?
there is no such thing as an exhaust coil. the ignition coil is the cylinder shaped thing that has a spark plug wire running to the center of the distributor cap
What does 45deg ATDC mean?
45 degrees After Top Dead Center.... used in terms for motor cylinder timing...ports (exhaust,transfer,etc)
Where are the casting numbers on a Pontiac 301 cylinder head?
The Pontiac V8 head casting numbers are usually found on the exhaust side of the head. I have seen them located just below the valve cover, over the two center exhaust ports, or over the end exhaust ports. Some heads cast the numbers below the spark plug holes between the 2 center and outer exhaust ports.
What is the top dead center for a 1987 Chevy chevette?
When #1 piston is at its upper most position in the cylinder bore and both intake and exhaust valves are closed
Which valves do you adjust at number 1 top dead center?
1 exhaust and intake. Each pair of valves should be adjusted when the cylinder is at the TDC of it's compression stroke.With #1 at TDC you can adjust 1,2,5,7 intake and 1,3,4,8 exhaust.
How to install new cylinder heads in a 2002 Ford Taurus do all pistons have to be set at top dead center or two at the time?
only one cylinder can be at top dead center (TDC) at a time, usually this is cylinder number one. remember: on 4-cycle engines each piston reaches the top of its stroke twice, once for ignition and once for exhaust.
Location of a 02 sensor on 89 Chevy Celebrity?
The location of the O2 sensor depends on which engine your Chevy Celebrity has. If it is the 2.5L 4 cylinder the O2 sensor is on the front of the exhaust manifold near the exhaust port. If it has the 2.8L V6 the O2 sensor is on the top center of the exhaust manifold near the firewall.
