0
When should compliance bushings be replaced in a 2003 Honda CRV?
Wiki User
∙ 10y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What are the steps to replacing swingarm bearings on a 2003 Honda 350 rancher?
Should have bushings in it?
What if the timing belt on a Honda crv was replaced at 95000 and is now 173000 when should it be replaced again?
Soon,
How many motor mounts on a 1988 Honda accord?
Not including Trans Mounts, Should be 2, on has 2 bushings in it, the one closer to the rear
How much should it cost to replace front control arm bushings on a 1996 Chevy blazer?
There are many bushings on a front lower control arm. However, i have a 2003 honda accord and it only needs the big bushing to be replaced and many shops quoted me around $200-260. All shops required to have the alignment done at the same time and it should be around $50-70 so shop around. Good luck
How much should it cost to replace rear bushings in a Honda Civic?
I don't know how much it should cost, but I know what it did cost on a 2000 LX model. At a Honda dealer in Bethesda MD the price is $587 parts and labor. I am sure that comparison pricing would result in a lower cost to the consumer. just recently (feb 2011) replaced 2 bushings on my 2000 lx civic. pepboys wanted ~$450 for labor and parts. cost me about $400 (labor and parts) by bringing it to local mechanic instead. (south eastern PA)
When should a serpentine belt be replaced on 2002 Honda CR-V?
if it is cracking exesively
Your 2002 Honda Accord sqeaks when turning or driving over bumps The squeaks sound like the springs on an old iron bed Other than the noise it drives fine?
Sounds like your front-end bushings may need to be replaced. Without the proper tools you should consult a mechanic.
When timing belt should be replaced in 2003 Honda Pilot?
It MUST be replaced every 105,000 miles or 10 years whichever comes first.
Does the entire drive shaft need to be replaced in a 1999 Honda CRV or can the Hanger Bearing be replaced?
Center bearing should be replaceable after removing driveshaft
When should you replace the fuel filter on a Honda Accord?
All fuel filters should be replaced at least every 2 years.
What is the cost to have a timing belt replaced in a 1992 Honda?
Honda what???????
Where to get rear upper control arm rubber bushings on a 1989 Honda Prelude?
your local honda dealership. they will have the exact match you need. i went to an advance auto for lower control arm bushings, and they were more expensive then the dealership. and on top of that too small! so i now go to the dealership if i need OEM parts for my 1989 honda prelude
