it is not a belt, it is a timing chain. i have seen them last for 400000 kms +, but chains do strech, so if you have over 250000 kms, i would consider it. hope this helps
NO there is not. The timing on that engine is computer controlled and it REQUIRES an engine scanner to set the timing. A timing light will not work.
Yes.
It has timing chain and gears. NO belt.
It requires an engine scanner to set the timing on that year engine.
The life expectancy of a timing chain on a 1999 454 Vortec engine is 5 to 10 years. The exact time depends on how often the vehicle is driven.
There should be a sticker on the fan shroud telling you which wire to disconnect. On the older tbi motors it was tan with a black stripe i believe. Disconnect this wire, the loosen the dist. bolt and check the timing with a timing gun. Rotate the dist. until you get the desired timing then tighten the dist. bolt and connect the tan wire. On a vortec engine you have to have a engine scanner to adjust the timing. But if there is no check engine light on then the timing is correct all ready. It is controled by the computor, There is no ajustment needed.
There is no ajustment for the timing on vortec engines the computor does it automaticly
The 4.3L V6 GM engine does not have a timing belt it has a chain, and it does not directly drive the distributor.
The only thing you can do is set the basic timing by ear good enough to get it running If you just put the distributor in the engine. The timing is not ajustable it is controled by the computor. It requires an engine scanner to set the timing, not a timing light.
the 1996 s-10 blazer 4.3 vortec has the computer in the engine compartment on the left hand side....if this is true, you cannot, I repeat, cannot adjust the timing.....the computer adjust the timing....you should be able to read it on the sticker under the hood..... ------- The timing is computer controlled - no way to adjust it, the computer does all of that for you.
If it is a vortec engine, then there is no timing ajustment. It's controlled by the computer
Timing chains are designed to last the life of the engine and are normally replaced during a complete engine rebuild. No maintenance is required.