answersLogoWhite

0

Which one?

Then my answer, "When it stops working within specifications by the manufacturer."

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Where is the control module located on a 1987 Nissan 300zx?

Where is the ignition control module on a 1987 nissan 300zx


How do you replace strut and coil spring on Nissan 300zx?

replace coil springs in a nissan 300zx


How do you replace multifunction switch on a Nissan 300zx?

i have a 300zx Nissan and i need to replace themultifunction switch i don't know how?


How do you test the Ignition control module for a Nissan 300zx?

If you can start the engine when cold, but it sputters and stalls when it's warm, then you most likely have a bad ICM. When you crank the engine, if you have tachometer movement, then the module is good, if there's no tach movement while cranking then the module is bad. The tachometer gets the signal from the module, so if the tach works, then the module is good.


Where is the drl module in a Nissan 300zx?

Passenger side front wheel well.


How do you fix the digital speedometer 1988 Nissan 300zx?

I've heard u can resolder the ground inside the control box but your best bet is to just replace it.


1987 300zx cruise control does not work?

If the cruise control on your 1987 300ZX does not work, you might have an issue with the cruise control fuse or wiring. You could also have a problem with the switch that turns the cruise control on and off.


How do you replace passenger side 300zx turbo?

Unfortunately you will have to remove the engine to get at it.


How do you tell if fuel pump relay is out on 300zx?

Replace it with a new one.


Where is the voice module in a 300zx 85?

it is located behind the pass side kick panel behind the main computer


When should you replace a water pump on a 300zx?

When it becomes loud or starts leaking. You can also change it if you have to do timing belt due to you have to take everything off anyway


How do you replace the oil pan gasket on a Nissan 300zx?

http://www.300zx-twinturbo.com/cgi-bin/manual.cgi Check out this link. I use this for everything when I work on my 300zx. This exact link will take you right to the section that gives step by step instructions on how to replace the oil pan gasket. Good Luck