This is what is known as a "short circuit".
It does not contain unidirectional outputAnswerA purely resistive circuit is an 'ideal' circuit that contains resistance, but not inductance or capacitance.
An electrical circuit used to measure an unknown electrical resistance is called a Wheatstone bridge. It is called a bridge because it balances two legs of a bridge circuit.
The total resistance in a series circuit is determined by adding (summing) the individual resistances of each component in the circuit.
If measuring resistance of materials or resistors by themselves(not soldered into a circuit board) resistance is constant. If measuring resistance of a circuit then it could fluctuate with the components functioning in the circuit.
On Circuit Resistance = Close to the total load Resistance. Off Circuit Resistance = Near Infinitive High Resistance.
resistance
It does not contain unidirectional outputAnswerA purely resistive circuit is an 'ideal' circuit that contains resistance, but not inductance or capacitance.
The unit of power measured is watt, irrespective of resistance, capacitance or inductance of the circuit.
a circuit with no resistance or zero resistance can be considered as open circuit in which the current is zero. without resistance the circuit just becomes open ()
An electrical circuit used to measure an unknown electrical resistance is called a Wheatstone bridge. It is called a bridge because it balances two legs of a bridge circuit.
Resistance, or electrical resistance. The SI unit is the ohm.
yes
No, the resistance in a circuit does not change when voltage changes. Resistance is an inherent property of the circuit.
Resistance is the ability to regulate the amount of charge flowing in a circuit.
(Electronics) Resistor placed in the emitter lead of a transistor circuit to minimize the effects of temperature on the emitter-base junction resistance and its resistance is called swamping resistance.
The total resistance in a series circuit is determined by adding (summing) the individual resistances of each component in the circuit.
Not sure what you mean. The equivalent (total) resistance in a parallel circuit is less than any individual resistance.