Corner tapping shall be used for installing orifices in pipeline size less than 2".
A restriction orifice (RO) is used to limit the flow through the pipe to a set flow by choking the flow at its sonic velocity. A flow orifice (FO) is usually used to determine the flow through the pipe from the pressure drop over the plate. There a normally two pressure taps (one on each side of the plate) and a pressure transmitter which determines the pressure drop over the plate. A formula is then used to convert this pressure drop to a flowrate for the specific fluid passing through the orifice. A FO usually has a temperature element to determine the gas temperature for use is the formula.
Use a self tapping screw, and screw the top plate into the grid for the ceiling tiles.
Use metric 6 mm or 1/4 inch self tapping screw to attach plate. ( North America only )
If you mean an "orifice tube", then yes.
To attach a front license plate to a 2005 Bonneville, simply place bolts through the plate and through the bumper holes in the front bumper. If no holes exist, you can use self-tapping screws to create them.
The rock climbers could not see into the dark orifice of the cave.
I have 1998 chev suburban with rear air do they use two orifice tubes
You would use "around" in this situation, as it implies a direction and not a shape. "He went AROUND the corner." However, in some situations, you may round a corner. For example, a baserunner in baseball passing by third base and heading for home plate can be said to round the corner towards home, in reference to the path in which the runner takes around the basepath. Rather than running a straight line to third base and then a straight line to home plate, the runner takes the corner at full speed and thus, ROUNDS the corner in an arced path.
look in the corner where the item is,when you move your mouse over it and it will say use and click on it good luck
The orifice meter is used with the orifice flow rate meter and measures things like the flow rate of natural gas. It can measure other things and companies use it for different things also. Some companies give lessons or classes in using the orifice meter.
on your plate
Use self-tapping screws. Before making holes with the screws ensure that the location is central and at the correct hight. Depending on the car, it may also be possibly to obtain a (very inexpensive) license plate and mounting hardware kit from a dealership.