Does it in my 98 also. In my case the shifter isn't perfectly in park. It is in park, but not far enough to let the key turn off. Hope this helps...
AnswerMy car did this and we needed to replace the igniton key tumbler (or something close to that) after replacing that and resetting the computer it works good. AnswerMy 97 grand prix has been doing this for quite some time. I've yet to have it fixed, but for me, when the car is in park, and the car is still on (not nessesarily engine running, but at least battery power) I usually have to push on the shifter towards the passenger side of the car (gently) until I hear a clicking type sound. There are two distinct clicks, and when it makes a certain click I can then remove the key. I know this sounds strange, and it could possibly just be a quirk with my car, but hopefully this will help. AnswerActually, this is a common problem with grand prix's. The cause is a bad shifter assembly which is around $350 to replace and is not covered under most warrenty's. In order to remove the key you will need to lift the steering wheel and place your hand, palm towards you, under the column approx. in the center towards the right side. You should feel a button. Push this button in towards the dash and then reach with your other hand and turn the key back. Another way to remove the key is to lift the steering wheel and there is a cover that can be removed. Remove this cover and then place something small through the hole. This will hit directly on the button allowing it to be pressed so you can turn the key to remove it.The ignition switch in a 2004 Pontiac grand am can be installed by first Sliding out old lock cylinder and then Press the small release tab While turning the key to the ON Position.
ignition starter switch
You will need to remove the retaining ring at the top of your 1995 Dodge Grand Caravan ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
change ignition switch and/or tumbler
The ignition switch is immediately behind and attached to the ignition lock cylinder. The ignition lock cylinder is where you place the key to start your vehicle. If you are haveing problems with your vehicle not starting and or turning the key, more than likely you need to replace the ignition lock cylinder. It is common for these to go bad in GM vehicles.
I know for my grand am, I have to leave my key in the ignition for 15 minutes.
it is located on the steering column
Your ignition lock mechanism is worn/damaged (How much junk do you have on that key ring, Bub?). It needs to be replaced.
change the Ignition Lock lock switch
I don't know how to change the ignition switch but I have some advice. Don't screw with the ignition switch, buy the whole steering column. It will be cheaper and easier to change.
BAttery?, starter? ignition switch?
unplug the battery for 2min