0
When you remove the radio the rado ask for a code you try too put it in 3 times then the word off apare on the screen now you have the code but you don not how too put it on?
Wiki User
∙ 18y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Do you need a special tool to remove a radio in a 2000 Honda accord?
most radio head units have tabs on the side where you need what is called radio keys to remove most times two butter knifes will do if you can see the tabs
When was Radio Times created?
Radio Times was created in 1923.
How do you get the radio out of a 1990 Geo Metro?
I have done this quite a few times so I'll give you step by step instructions. #1. Remove the trim or bezel from around the radio, this just snaps in and snaps out so no problems there #2. You should see 2 to 4 screws on each side of the radio, unscrew these and keep them where you'll remember #3. remove the radio and unplug the 2 wires on the back, then install the new radio and put back in the screws and bezel. Its very easy once you get ahold of it. Good luck.
How do you take out a radio from a 2003 Nissan Micra?
As a previous techy for Nissan i have done this many times. Ensure you have a radio code beforehand though, once you unplug the set, you will need to input a new one when you put it back in. The following set of instructions is for the latest shape micra, the "bug". 1. Open both front doors 2. Remove the door seals 3. Remove the dash top by pulling upwards 4. Remove the bracket from under the dash top bolding the radio in (3x10mm bolts). make sure you don't drop these as they are quite awkward. You don't take the radio out as a single unit, you take the radio, trip computer and vents out as one unit. 5. Remove the plasstic caps inside the little compartment at the top, and remove the two screws. 6. Remove the two screws UNDEREATH the section of trim you are going to remove, just above the heater controls. 7. Pull the radio along with everything else out as one. 8. Remove all connectors ensuring you remember where they go. 9. Put everything you have removed on a carpeted table to stop scratches, and gently remove the vents by pressing the clips back that hold them in place. 10. You can now access 4 screws that hold the radio into the frame, remove them as well as loosening as many screws as you can see that hold the together, i remember i used to loosen a certain 4. 11. With the frame loosened it is now possibe to remove the radio from the frame, otherwise its too tight. Hope that helps,.
What is the duration of Radio Times With Marty Moss-Coane?
The duration of Radio Times With Marty Moss-Coane is 1.67 hours.
What actors and actresses appeared in Radio Times - 1980?
The cast of Radio Times - 1980 includes: Doug Aston Laurie Dee
How do you remove a led tv from wall?
The best way to remove an LED screen is to have a friend or if a large screen have several friends help. If you are not careful you could either break the unit or hurt yourself. First look behind the screen to see if you can determine how the unit is locked in place. Some times there is a pin on either side, some times a kind of latch or hook that clamps down. The monting bracket is bolted to the wall, the other part that attaches to the back of the Screen is a different piece, most often the Screen bracket sits on top of the mounting bracket. Once the latch or hooks that keep the two together are released the unit should lift up and off. Victor Brodt 7StarsGreen.com
Where is the penguin times archive?
At the top of your screen
Where is Club Penguin times?
At the top of your screen
Which advertisement contains the slogan If its on its in?
RADIO TIMES
A flat screen television has a rectangular screen that is 29 inches high and 32 inches wide What is the surface area of the screen?
Surface area is length times width (or width times length). In this case, 29 times 32 = 928 square inches.
A flat screen television has a rectangular screen that is 29 inches high and 32 inches wide. What is the surface area of the screen?
Surface area is length times width (or width times length). In this case, 29 times 32 = 928 square inches.
