0
They are along the top of the engine. You must remove the vortec 4200 resonator box from the top of the motor then you will see six electrical connections. These are the coil packs and are held in place by long skinny bolts bolts so do not apply too much stress. If they are very tight then tap them with a small hammer to break any corrosion. Remove them one at a time and pull it up and out of the way. The spark plugs are in the well. Replace with AC Delco Iridium. Do not adjust the gap on these plugs as the protective finish on the electrode is important for the plug life.
www.trailvoy.com - All the answers for you truck from enthusiasts!
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where are the spark plugs located on a 2001 Chevy blazer?
in the trunk
Where is spark plugs located on 2003 trail blazer?
under the passenger side rear hub cap ...... huh?
Where are the sparks plugs located on a 1993 Chevy blazer?
if you have to ask this question, then you shouldn't attempt to change them...
Chevy blazer 1998 changing spark plugs?
== ==
Where is the coolant temperature sensor located on a '95 Chevy Blazer?
On the drivers side between the back 2 spark plugs and just a little lower than the plugs
Where is the temperature sending unit located on a 1999 Chevy blazer?
It is in the driver side head, between the first two spark plugs.
What is the pattern for spark plugs on Chevy s10 blazer?
They are lined up like this on my 1995 Chevy blazer 4.3 L, V6 1,6,5,4,3,2
Where is the distributor located on a 1991 Chevy S10 Blazer?
4.3? Follow the spark plug wires from the spark plugs, they will lead you right to the distributor.
Where is the flasher relay located on a 1995 Chevy blazer?
Under the trim panel just to the lft of the lighter and power plugs. It's a pain to get to.
Are there freeze plugs on the end of the head of 1996 Chevy s-10 Blazer?
no
Do you need to reset computer on your 1999 Chevy blazer if you change spark plugs?
No.
Where are the spark plugs on a Chevy Blazer?
They are in the heads where the exhaust manifolds are bolted to the heads. The plugs have rubber wires hooked to the ends of them.
