0
Where are all the sensors located on a 1989 jeep Cherokee Laredo?
Wiki User
∙ 12y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the best oil viscosity for a 1989 Jeep Cherokee Laredo?
The best oil viscosity for a 1989 Jeep Cherokee Laredo is 10w-30. This type of oil is designed to give a good balance of lubrication and protection.
What engages the axles on a 1989 Jeep Cherokee Laredo?
I believe it to be the transfer cases.
Where is the speed sensor located on a 1989 jeep Cherokee Laredo?
Look on the back on the transfer case. There should be one wire running from it. That's your speed sensor. -- Blake.
Where can you find a serpentine belt diagram for a 1989 Cherokee Laredo?
any auto zone can print it out for you.
What is the maximum size tire you can fit on a 1989 jeep Cherokee Laredo without lifting it?
31 inches
Is a 1989 Jeep Cherokee instrument cluster compatible with a 1992 Jeep Cherokee Laredo?
yes NO, The 89 uses a speedometer cable where the 92 is electronic.
What type of trans fluid do you use in your 1989 jeep Cherokee Laredo it has a six cylinder with an auto trans?
dextron II
Why will my 1989 jeep Cherokee Laredo headlights not go off?
sound like a bad dimmer switch hi/low beam
Where are the oxygen sensors located in a 1989 Toyota sr5?
Oxygen sensors on a 1989 Toyota SR5 and located near the catalytic converter. The sensors read the emissions from the vehicle so the ECU knows ho much fuel to run in the engine.
White frothy oil in your 1989 Cherokee Laredo?
sounds like you have water in your oil. it could mean you a cracked block or cylinder head
Why do I have no running lights front or back and no tail lights- head lamps signals and flashers work fine-1989 Jeep Cherokee Laredo?
Your Electronic Ignition Switch is bad. It is located on the inside of the jeep under your steering column.
What would cause the computer in a 1989 jeep Cherokee Laredo to go bad over and over again?
more than likely you have a short in your wiring
