do you have any pictures were the blend door actuator is located on a Jeep grand cherrokee limited 2002
Listed on the drivers door post.
Check the label on the drivers door jamb, it will list original size and recommended pressure.
It depends, some are in the door, some are in a fuse box.
No, the XJ Cherokee does not have the same heater box as a WJ Grand Cherokee.
It must be on the same location as in my 96 Grand Cherokee. Behind the spare tire there is a small door you can open and there you find that module. You got to remove the spare tire to see it.
Yes
You have to remove the door panels
Listed on the drivers door post.
Of course, it can. However, the more common problem is a broken blend door, particularly on the Limited edition. Check heatertreater.net for diagnostic information and an inexpensive fix.
Rubber gasket around door shrinks and allows rain to enter. I have a silver car so that the duck tape blends right in.
dealer or junk yard. ahhh, is this a "real question"?
open the passengers door and look at the side of the dash board that closes against the door you will see a litte door that says fuses on it.
dealer or junk yard.......hello?????? make some calls.
you close the hood all the doors and use the key and lock and the drivers door then reopen the drivers door
Put your key into the driverside door and slowly turn it to unlock. I found this is sometimes in the passenger door, and sometimes in the hatch.
Your owners manual should instruct you on how to do this.
it depends where you are in the world eg America or a chryslerjeep parts store