0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How much fuel should a 1984 Mazda 323 take when completely empty?
About 14 gallons
Where is the timing marks rover 25 1.4?
can you tell what are the marks for a rover 25 14 on a 52 reg for got to mark it up thanks
Where do you set the timing on the cam sprockets for a Mazda mx6?
This is according to the Chilton's manual. Locate the timing marks on the crankshaft pulley and timing belt lower cover. Start the engine and allow it to come to normal operating temperature. Make sure ALL accessories are OFF. Check idel speed and adjust if needed. (approx. 650 RPM). Turn off the engine. Connect a jumper wire between the TEN terminal and the GROUND terminal at the underhood diagnosis connector. Connect an inductive timing light according to manufacturers instructions. Start the engine and allow it to stabilize. Aim the timing light at the timing marks. The mark on the crankshaft pulley should align with the specified BTDC degree mark on the timing cover scale plus or minus 1 degree. (1995 mx6 2.5l engine is 10 degrees BTDC). There should be a sticker on the inside of the hood that has the specified timing for your car on it. If not, you can call a dealer and get that info. If the marks are aligned, then your timing is good, if not, then you need to adjust it. Loosen the distibutor lock bolts just enough to turn it. While aiming the timing light at the timing marks, turn the distributor until the marks are aligned. Tighten the distributor lock bolts to 14-19 lbs and recheck the timing. It is now set. Disconnect the jumper wire from the diagnosis connector and disconnect all test equipment. I just did this yesterday and it worked great. Good Luck!
What is 22638 over 522291 in simplest form?
It is: 14/323
What size is 323 sq feet?
14 x 17
What is 4526 divided by 14?
323.2857
What is the ignition timing specs for Mazda astina 1997?
5 degrees BTDC (Before Top Dead Centre) is the spec I found for the fuel injected 1.5l 16v. You can run timing at + or - 1 degree on this 5 degrees (i.e. Timing at 4 degrees or 6 degrees BTDC. i have seen on Mazda forums where guys run 10, 12 & even 14 degrees but I guess this depends on the octane rating of the fuel you use.
When was Tread Marks created?
Tread Marks was created on 2000-01-14.
When was Bruce Marks born?
Bruce Marks was born on 1957-03-14.
How many punctuation marks are there in English grammar?
We have 14 punctuational marks in English
How many degrees of timing does the 91 Mazda miata have?
10 degrees BTDC is stock. The car feels a little peppier at 12 or even 14 degrees (listen for pinging or run premium at 14). You have to jump the "gnd" and "ten" connectors with a paper clip when checking the timing (under the lid of the black "diagnostic" connector). You'll know you jumped the right two pins if you hear a slight idle change and the timing mark stops jumping around.
How long is the 2012 Mazda Mazdaspeed3?
The 2012 Mazda Mazdaspeed3 is 14 ft. 9.6 in. (177.6 in.) long.
