IF YOUR BLOWER ONLY RUNS ON SOME OF THE SPEEDS YOUR PROBLEM IS 99% OF THE TIME THE BLOWER RESISTOR LOCATED UNDER THE GLOVE BOX VERY EASY REPAIR. TAKE THE BOTTOM PLACTIC COVER OFF UNDER THE GLOVE BOX THERE ARE THREE SCREWS . WHEN YOU DROP THAT DOWN YOU WILL SEE THE RESISTOR. TO SCREWS ARE ON THAT AND YOU MIGHT HAVE A WIRE TIE WITH A SCREW IN IT TO MOVE THE WIRE OUT OF YOUR WAY. THE PLUG IN THE BACK OF THE FAN IS THE HARDEST PART OF THE JOB GOOD LUCK THE PART IS APART 15.00 AND THE GARAGE CHARGES ABOUT 70.00 TO DO THE JOB ABOUT A TWENTY MINUTE JOB
Should be near or attached to the blower motor
it should be located in the engine compartment,against the firewall.
On my 2002 it is located on the air plenum just below the blower motor on the passenger side fire wall inside the engine compartment.
how to install a blower motor for a 1994 Toyota pickup
In the fan box behind the glove box.
By blower I assume you the motor.It is located under the hood,where the right inner & outer fender meet the firewall.
Yes, located in the blower motor resistor pack. Follow the wires backward from the blower motor to find it.
On the right side under the dash, behind the glove box.
The blower resistor assembly is located on the heater case to the right of the bloser motor. - Haynes Repair Manual #36071, 1993-2005 Ford Ranger Pick-ups
The blower motor relay only operates the high speed function. That relay would be in the fuse/relay center under the hood.
toyotas have a resistor bank in line with heater motor each speed has a different value resistor. there is no resistor on high speed. it is located on passenger side in heater duct I thank it has two screws holding it on when you get it out you will see the resistors burned
The 2005 Ford F1 50 pickup truck blower motor resistor pack can be found on the firewall in the engine compartment. The blower motor resistor pack is on the passenger side of the firewall.
passenger side of vehicle under hood right next to fender
Remove blower motor 97 GMC jimmy
Under the hood on the passengers side near the blower motor attached to the housing......... I'm pretty sure that's where the "Relay" is located not "Resistor". The resistor may be located under or behind the glovebox.
Blower motor resistor assembly is located under dash board on passenger side.
Under the hood, on the firewall, passenger side, very close to passenger fender.
In the truck!
you turn it to the west
Under the hood, passenger side firewall, not far from the blower motor.
Most likely a failed blower resistor.
where is the VIN located on a 1937 ford pickup
It is located back of the glove compartment, once you remove the glove compartment you will see it right back of the three connector. I hope it help
You didn't mention what model you have but if it's a full size pickup the resistor is located on the passenger side just above the foot area next the the blower motor. Two small screws (5.5mm) hold it in place.