Jeep Grand Cherokee
Jeep Grand Cherokee Laredo
Jeep Grand Cherokee Limited

Where are the grease fittings on a 2000 Jeep Grand Cherokee?

202122

Top Answer
User Avatar
Wiki User
2006-08-12 19:45:46
2006-08-12 19:45:46

There are 2 grease fittings on 1999-2004 Jeep Grand Cherokee suspension components, there are only 2 on the top behind both front wheels. Those are the only ones.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

There are no grease fittings, they are sealed units. If a part wears out the replacement part will have grease fittings if required.

User Avatar

I would like to know where to find the grease fittings on a 2000 F/Mustang.

User Avatar

There are no grease fittings on this vehicle. Many aftermarket parts do have them, though.

User Avatar

From the factory it did not. Aftermarket replacement parts could have grease able fittings.

User Avatar

I'm not sure what year Dodge started this , but we have a 2000 Durango and we were told they do not have greasible grease fittings they are sealed factory fittings ! Cannot be greased !

User Avatar

If the components are original they are sealed with no grease fittings

User Avatar

A grease gun end goes right on the fittings.

User Avatar

all the ball joints are self lubricated, meaning no grease fittings, you cannot grease them or the steering joints, you can grease the front and back u joints on the drive shafts,but that is all.

User Avatar

The current generation, 2000-2013, does not have any.

User Avatar

Your 2007 Jeep Grand Cherokee 16 inch aluminum wheels will fit on to the 2000 Jeep Cherokee Sport. Any wheel larger than 16 inches will not yet on to the 2000 Cherokee.

User Avatar

where is engine block heater on 2000 jeep grand cherokee 6 cylinder engine?

User Avatar

The fog lamps are activated on a 2000 Grand Cherokee via the headlight switch. Pull the END of the lever OUT.

User Avatar

There are not any unless parts have been replaced and the new parts have them.

User Avatar

There wasn't a 2003 Cherokee. The last Cherokee was 2000.

User Avatar

Wrangler up to 2006, Cherokee up to 2000. Grand Cherokee up to 2004.

User Avatar

The 99 does not, so it's likely that the engineers at GM skipped this useful doo-dad on the 2000 also. Too bad, as the greasing helps the suspension last far longer than the sealed units...

User Avatar

no... all bearings, seals, and bushings are sealed and when they go there is nothing to do but to get new ones

User Avatar

On 2000 Grand Cherokee with the 4.7L with the 45RFE transmission it is located on the passenger side engine compartment at the rear near the fire wall.

User Avatar

00 Jeep Grand Cherokee, measurement of caliper from pin hole to pin hole.

User Avatar

yes it will bolt up but not real sure if the wireing is the same


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.