The spark plugs on the 2001 Eclipse Gt are set up like this. The 3 front one are easy to locate and change. You remove the 3 spark plug wire directly in front of you out of the valve cover (I suggest doing it one by one). You'll notice that the spark plug wire exstends down in to the valve cover 3 to 4 inches, so 3 to 4 inches down inside you valve cover is your 3 front spark plugs screwed in to you engines heads. The rear 2 are alot more tricky to locate and replace, your looking at around a 2 hour job, if you've done it before. To locate the other 3 rear spark plugs, you have to remove your intake manifold. This requires you to remove your air intake system, and various other wires and tubing. Once you have removed all of that you'll notice basically the same set up as the front 3 spark plugs. The one thing I am not for sure is if there were any gaskets to be changed for the intake manifold once it was removed. The gaskets should be changed since the would break or will be about to break. Cofres
You don't. The gap is not adjustable.
it has two that i can find
remove the intake manifold then they're in the back. I'm sure u see the front 3. peace
Most had a V-6 under the hod, which would mean 6 spark plugs.
remove intake manifoled to access back 3 plugs. time consuming but can be done
how do you route the alternator and ac belt on a 2001 Mitsubishi eclipse
by puting ur bulb in ur girl friends hole
all drain plugs are located at the lowest point of the oil pan.
how to change spark plugs on a 2001 expedition
there are four spark plugs.
How do you change the spark plugs in 2001 lexus rx300?
I just finished replacing the starter on a 2001 4 cylinder Mitsubishi Eclipse. You can watch the video here: http://eturkov.blogspot.com/2008/10/diy-2001-mitsubishi-eclipse-starter.html