0
The two bolts on a starter motor are typically located on the mounting flange of the starter, securing it to the engine block or transmission bell housing. They are usually accessible from the bottom of the vehicle, and their exact positioning can vary depending on the vehicle make and model. In most cases, one bolt is positioned at the top and the other at the bottom of the starter motor.
What else can I help you with?
1994 custom buick lesabre starter bolts unreachable how to raise engine to remove starter?
where are the two bolts located on the starter?
How many bolts on a starter for 85 celebrity?
Two bolts hold the starter to the block. There may also be a brace on the other end of the starter.
Are there brackets holding the starter on a 1997 neon?
no brackets just two bolts, one of which passes through transaxle and bolts into starter
How many bolts in 2000 Mercury Sable starter?
The 2000 Mercury Sable starter will have three retaining bolts. There will be two cable retaining nuts on the front of the starter.
How many bolts to the starter on a 1994 Ford Thunderbird?
two
How do you change a starter on a 1996 suburban?
Disconnect the battery. The starter should have two or three bolts holding it in. And there will be wires connected on it. Loosen the bolts and wiring connectors, then remove the starter from its mount.
How do you replace a Honda Civic starter?
A Honda Civic starter is found on the transmission. The starter is mounting with two bolts. Loosen the remove the bolts, then disconnect the starter solenoid from the wire harness. Replace with a new unit.
How do you get off a starter on a 99 Dodge Caravan?
Disconnect wires then two bolts holding starter to trans.
Where are the bolts for the starter located on and what size a 1987 Toyota Supra?
It's on the transmission, two 14mm bolts.
How do you replace starter and coil on a 94 eagle talon 2.0 non Turbo?
your starter is on the top of transmission there are two bolts and i ground wire is bolted to one just take the two bolts out and it will wiggle out
How many bolts on 99 silverados starter?
The starter on a 1999 Chevrolet Silverado typically has two bolts securing it to the engine. These bolts are usually 15mm in size. Always check the specific engine configuration, as variations may exist, but the standard setup generally involves these two bolts.
How do you get the starter bolts out of your 350?
Starter bolts on the 350 are probably the EASIEST to get to of just about any vehicle. The two starter bolts point STRAIGHT DOWN. Just put a wrench on them and turn. But make certain that you've disconnected one of the battery terminals first.
