Want this question answered?
There are 3 drain plugs on the Toyota Tundra V8 engine and radiator. On the radiator petcock, the plastic thumbscrew, and drain valves are on the bottom, driverâ??s side of the radiator.
denso plugs denso plugs
I just replaced the plugs on my 2005 tundra 4.7 v8. they are easy. their is so much room to work with. But do use the genuine Toyota spark plugs. "Do not use aftermarket plugs" i garauntee if you use the aftermarket plugs, you will wreak havoc. the heat range is too high on the aftermarket plugs, and therefore will burn holes in the ignition wires. check eBay for Toyota plugs or your local Toyota dealer.
No. Toyota plugs need the 2 prongs. Iridiums only have one prong which will not work. Try Bosch if you'd like.
There are actually three coolant drain plugs on the 2001 Tundra. Speaking of a 4.7 liter engine, there is one drain plug at the bottom of the driver's side of the radiator. The skid plate/splash shield need to be removed in order to access this. It is a plastic butterfly type and should be easily removed by hand or with the aid of pliers. The other two are located on the driver's side of the engine block. This truck takes over 12 quarts of coolant so these two drain plugs need to be opened in order to completely empty the coolant from the system.
Changing the spark plugs on a tundra you remove the cover over the plug then carefully remove the plug. Make sure that you only do one at a time so as not to mess up the firing order. Hope this is helpful.
Which drain plugs?
Oil drain plugs, Coolant drain plugs, spark plugs, need to know which plugs you are asking about.
24mm or use a 15/16 for a little tighter fit if its dorked up
against the bulkhead, next to the ecu
no drain plugs. need to drop the fuel tank below the vechice. no drain plugs. need to drop the fuel tank below the vechice.
There should not be a coolant drain on the engine block. You are probably looking at a freeze plug which should NOT be removed. The freeze plugs where openings for the original production/casting of the engine block and are sealed.