Well, I would recommend purchasing fuel lines offered at Auto Parts Warehouse because they offer a variety of products for an incredibly reasonable price.
Where to buy fuel line for 1994 Chevy 5.7 fuel line suburban?
can byou buy a permanent in-line fuel gauge for a 1992 corvette
drain the fuel, remove the fuel filter from inside the tank, remove the old fuel line from the filter, remove the old fuel line from the carb, pull old fuel line out, install new fuel line through the tank, reconnect fuel filter to new fuel line, place filter and slack line into tank, connect new fuel line to carb, refill tank, check for leaks.
Dont. Just cut the line and use a universal fuel filter and some fuel hose
Try SuzkiCarParts.com Yes they have tracker parts
Yes if you buy the right fuel line remover tool for you car and the replacement hose.
Take the old line to the repair shop and buy new, pull the line out of the tank, get the fuel filter out of the tank. Cut the end of the new fuel line to a 45 degree angle and start putting it in the hole in the fuel tank. Grab the line thru the filler neck (use needle nose pliers) and pull about 5-6" of the line thru, cut the 45 degree angle off and make it 90 degrees and attach the fuel filter. Put all the line you pulled thru into the tank. Cut the remainder of the line to length and attach it to the carburetor.
To fix a fuel line on a 1993 Chrysler New Yorker, first ensure the vehicle is parked safely and the engine is cool. Locate the damaged section of the fuel line, then relieve fuel pressure by removing the fuel pump fuse and starting the engine until it stalls. Cut out the damaged section and replace it with a new fuel line, using appropriate fuel line clamps and ensuring all connections are secure. Finally, recheck for leaks before starting the engine.
To replace the fuel line on a Talon whipper snipper, first, ensure the engine is off and cool. Remove the fuel tank cap and drain any fuel, then detach the fuel tank from the body by unscrewing it. Cut the old fuel line at the connections, then measure and cut a new fuel line to the appropriate length. Finally, attach the new line to the fuel filter in the tank and the carburetor, ensuring secure connections before reassembling the tank and adding fuel.
Install a new line.
The fuel lines on your 1987 Ford Crown Victoria are held in place with a swivel nut on each end of the fuel line. Loosen the swivel nut to remove the fuel line. Reverse the process to install the new fuel line.
There isn't one. Buy an in-line filter and about a 3inch piece of fuel tube, pull your fuel line off of the petcock (little thing where you switch fuel between on, off and reserve). Put the old line into the filter and the new line from the other side of the filter back in the petcock. Make sure the filter is tightly screwed together too, sometime they come in the package real loose and you don't want fuel all over your bike.