do you mean a turbo? if i were you i woulg have it professionally installed
where is voltage regulator on 1999 altima
How do you replace a water pump on a 98 nissan altima?
I need to replace the back window of a 1999 Nissan Altima how do I do this
timing chain diagram for 1998 Nissan altima
Not sure about a 1999 but on a 2000 the blower relay is on circuit C-108 in the Junction Box.
I own a 1999 Nissan Altima, depends if its GX or GXE, from 15.9 Gallons to 20 Gallons.
How do you change the spark plugs in a 1999 Nissan Altima. Can not get socket on the plug.
The oil dip stick on a 1999 Nissan Altima is on the side of the engine closest to the radiator. It is just behind the alternator.
I have a 1999 Nissan Altima and currently has 156000 on it. The manufacturer recomendation for the timing belt is every 75,000 miles.
in the fuel tank
Check the fuses first and the blower relay.
Tire air pressure is dependent upon the size and type of tire. The 1999 Nissan Altima standard tire air pressure is 32 pounds.
It can cost between $70 and $150 to repair the 1999 Nissan Altima Tie Rod. It will vary based on where the parts are bought and who makes the repair.
The Heater/Blower Relay is on the blower motor housing under the dash in the passenger compartment on 1999-2002 models
it says it on the speaker, in 94 it was clarion
Belt. no a tinning chain
How do you replace the flasher on a 1999 Nissan altima?" The Turn Signal Relay in a 2001 Nissan Altima is on the right side of the steering wheel at about knee height. You will have to remove the bottom plastic dash part by the removing two screws on the left and right bottom sides of the plastic panel, then carefully pull the top part until it comes loose. The relay is up under the dash on the right and is attached by a screw. Its a black rectangle box about 2 inch by 1 inch in size with an electrical plug on the bottom. Hope this helps!
There could be a few reasons why the radio will not work in a 1999 Nissan Altima. A fuse could of blown or the radio needs to be replaced.
.039 according to NGK's website.
Probably the wrong voltage