I have the Key, But use a Bike Key for a Schwinn Bike with Hex nuts (12.99) It's a Y shape, and has 3 of the sizes needed. Try any better bicycle shop for this key. I think they call it a hex wrench or Service Wrench (Although it's NOT a wrench)
Better yet go to your local sears and buy a hex set that will fit onto your cordless drill it takes them off and puts them off 10Xfaster.
First remove the vent panel that goes across the top of your dash it will snap out of place. Then remove the two screws that hold the center dash piece (where your radio comes through) in place at the top just in front of the tray on your dash. Then after removing the ash try pull on that dash section. It snaps in and out of place. Then there are 4 screws that hold the cigar lighter panel in place.....there you go.
Go to the dodge place and ask THEM to remove it
Usually to remove the front bumper grill you would just locate the screws or bolts holding the part in place and then remove them. The grill should be able to be removed after that.
heater resistor will be located in the upper section of the plastic trunking for the air flow from the cowl grill. It should have 3 prongs fitted for the wiring and normally 2 screws to hold it in place. Remove the screws and the resistor should pull right out.
If it's the same as my 1995 Ford Explorer XLT , open the liftgate and there are 2 screws at the top of the lense , remove the screws and carefully pull the lense straight back towards you ( besides the screws there are pins >>>>>>> that hold the lense in place )
You will need to remove your steering wheel and remove all internals. There is a 10mm bolt that holds the ignition in place. When you remove that it will slide right out.
Remove the two slider screws that hold it in place.
ÊUsing a screwdriver, remove the screws from the center console panel.Pull the panel off,use the screwdriver to remove the screws holding the radio in place, pull the radio out and remove any wiring connections.Ê
remove the torx screws that hold in place, remove the bulbs from sockets
The radio on a 1987 Honda Civic is held in place by the center console. First remove the center console to reveal the several mounting screws holding the unit in place. Remove the mounting screws and pull the radio out of the car.
First you will have to remove the who steering wheel surrounds. Once this is removed, you will see the screws that are holding the ignition switch in place; remove those screws and then unhook all the wires.
The Chevrolet equinox front speakers are held in place with two retaining screws. Remove the retaining screws and the wiring harness. The speakers will come out.