You can go to Autozone.com and theres a link there you can type in what diagram you need and it pulls it right up
replace rear axle bearing
you will have to have the axle pulled at a shop.the bearing slides along the axle shaft and seats in the axle housing.
You can find a 1989 Chevy front axle diagram at most Chevrolet dealerships. Most local libraries will have Chevrolet service manuals with the front axle diagram.
You can replace the front wheel bearing, on your Kawasaki Mule 3010, by removing the axle. With the axle Remove the wheel bearing will slide off.
rear axle diagram ford 350 2004
Assuming rear wheel drive and you're replacing the rear axle seal and bearing with drum brakes: With rear axle off the ground, on stands or blocks and parking brake OFF, remove tire/wheel. Pull brake drum, check for retaining plate that holds bearing, it's usually a 4 bolt square plate near the center of the axle. With the axle off, attach an axle shaft puller to the axle and slide the weight vigorously down the shaft until it pulls off. You will need to take the axle shaft to a shop that has a bearing press so that you can remove the old bearing and install the new one. Many auto parts retailers have a bearing press and won't charge to remove and replace a bearing from the shaft if you buy the parts from them.
It is a bearing that has been neglected to the point that is has overheated so much that it is now bonded to the bearing race & axle. Very difficult to remove without damaging the axle. Good luck, getting it off.
Remove the tire and wheel. Remove the axle end. Remove the axle seal. Remove the wheel bearing. Reverse the process to install the new wheel bearing.
Begin by removing the tire and wheel from your 2002 Dodge. Remove the end of the axle. Remove the wheel bearing nuts. Remove the wheel bearing. Reverse the process to install your new wheel bearing.
Remove the rear wheel from the axle. Remove the brake pads and hardware. Remove the axle end cap. Remove the bearing. Reverse the process to install the new bearing.
If you do not change a bad wheel bearing the bearing will cut a groov in the axle.If it goes on long enough the axle will have to be replaced.It could also ruin the axle housing.Then you would have to replace the rearend.
When working on a car, it can come in handy to have a diagram of the parts. The parts diagram of this cars rear axle can be found in its maintenance manual.