Car Fuses and Wiring
Chevy S-10
Ford Escort LX

Where can you find a wiring diagram for the ignition module on a 1986 ford escort L 19L carburated?

535455

Top Answer
User Avatar
Wiki User
Answered
2006-07-28 19:41:18
2006-07-28 19:41:18

go to the ford dealer and have them photocopy the appropriate pages in the 1986 escort e.v.t.m. (electrical-vacume troubleshooting manual) your welcome, mo the ford tech

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


The ignition module is mounted to the side of the distributor. It a rectangular piece.

Please check your spark plugs,wires,distributor and rotor or the ignition coil module. My '93 LX has an ignition coil module.

Not sure on a zx2. On an Escort LX it is behind the fuse box in the engine compartment.

under the ignition coils. it is flat comes off after you remove the three numbered igniton coils. they plug into the module underneath them.

CAR GUYS.COM OR YOU CAN GO TO YOUR LOCAL LIBRARY

Recently had same experience with my dodge and escort. in the escort it was the distributor and the dodge was the brainAnswerCheck your ignition module in your distributor that is a good place to start.

where is the ignition module located on a 1988 Mazda b2200

The engine computer is the ignition module.

The engine computer is the ignition module.

Where is the ignition module 97 explorer

There is no governor on a 91 Escort. There may or may not be a maximum rpm limit in the ignition module or computer, and there may be a maximum speed (mph) setting programmed into the ECM.

the ignition control module is operated by the pcm,the pcm tells the ignition control module when to energize the coils to enable spark

Begin by removing the wiring harness from your 1998 Chevrolet Suburban ignition module. Remove the ignition module retaining screws. Reverse the process to install your new ignition module.

Passenger side of the firewall, the engine computer is the ignition module.Passenger side of the firewall, the engine computer is the ignition module.

The 1996 Mitsubishi Eclipse ignition module is located on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.

the ignition module is located in the distributor

ignition control module is under the distributor cap

The engine computer is also the ignition module.

The 1993 Hyundai ignition module is located on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.

ignition module on what?

If by control module you are referring to an ignition module then you need to remove it from the distributor and take it in to a shop for testing ,it requires special equipment for testing.A new module runs from $50-$100 depending on model

Remove the ignition module retaining ring. Pull the ignition barrel out. Remove the wiring harness from the back of the ignition barrel. Reverse the process to install the new ignition module.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.