Want this question answered?
In the switch
On a 2000 Ford Ranger the only engine that uses a timing BELT is the 2.5 liter four cylinder engine ( I have no idea of what you mean by a " delay switch " )
where is the wiper switch located on a 85 el camino w/pulse wipers,the car has tilt wheel
perhaps the wiper switch is broken and needs to be replaced.-- The delay part of the Switch.
The delay system may not have anything to do with the switch. It depends on the manufacturer but the delay system maybe part of the wiper motor assembly...or the delay is sometimes located in a separate module located separately from the control switch.
Yes Many have a time delay adjustment or selector switch to pick how many minutes the delay will be
There is no time delay switch. The light has 3 positions on the switch at the light. On, Off, & On when the door is open. Check that switch. If that is not it, then you may have a bad door switch.
The engine light can come a vehicle for many reasons. If the transmission is having a delay, it could possible make an engine light come on.
It's on the wiper control switch on the multi-function switch.
This should not happen, change the switch out for a new one.
Switch is held in with two 5/16" nuts on the backside; if you have delay wipers, you'll have to take out the screws that hold the wiper delay unit from the bottom of the dash to get to the switch nuts.
I'm figuring that this is the same as my 1999 town and country, and I just replaced the wiper switch.. It was easy, and it cost 76.00, and it also had NO effect on the operation of the delay in the wipers. Incidentally, I was trying to fix the delay - What my vehicle does is the delay will work about 4 times, then the wipers "jump" slightly, and the delay no longer works. you have to cycle the wiper switch on and off to get them to go again. Good luck!