Napa, or even most autopart store will carry these. If they dont have them ,they will order them for you. I would suggest calling/shopping around before deciding where to buy them.
Incidentally, i do not
Disconnect any wires, and remove the 2 pins that face up and down. You should have someone hold the door, while someone else removes the pins.
Hey Lee==Simply remove the hindge bolts and remove the door. Some are welded on and you sometimes can remove the hinge pins. GoodluckJoe
Remove the inner kick panel. Disconnect the wiring harness. Drive the pins out of the hinges - remove door.
The bottom of the pins may have to be ground off to be removed. The pins are tapped upward to be removed. The door can be taken off to make access easier, or the door has to be supported to keep pressure off of the pins and to hold the door while the pins are out,
it is just inside the door on my 97 i couldn't find it either till i had to replace the pins in the hing... as i pulled on the door the came out of the door...
need to replace door hindge pins and bushing,how do we get door off safely.
there is page thereAnswergo to www.oversize door hing pins .com Answergo to www.oversize door hing pins .com LMC TRUCK PARTS HAS THEM , also ORIELLYS AUTO PARTS.
To change door pins on most vehicles, the old pin needs to be cut off with a blow torch. Then, the new door pin is welded in its place.
If the door is not lining up correctly it is probably the pins and bushings are worn out. Replace the pins and bushings and the door should close correctly. Pin and bushing kits are available from your local auto parts store.
Look here http://www.hotrodders.com/forum/99-tahoe-door-pins-136678.html
Open door look at the hinge remove two pins holding it on and remove door place it on ground, pick up new door put pins back onto the hinge well holding door and you should be done.