That particular part (shifter cable, including the bushings) has been discontinued. I tried finding the same piece for my cable and that's what Chevy told me. You'd have to either go to a scrap yard and find one from an old Lumina, or another car that uses the same cable part. Or replace the cable with something else that works.
The 1997 Chevrolet Lumina shifter cable is held in place with a swivel nut on each end of the cable. Loosen the swivel nuts and the cable will come off.
The shifter cable connects the shifter to the transmission.
1. Take out your center console 2. Remove the floor pan grommet mounting nuts 3. Remove the retaining clips and pry the cable off (If the bushings are shot, there won't be much prying needed) That's all there is to it.
The 1997 Chevy Blazer shifter cable will have swivel nuts on each end of the cable. Connect the shifter cable and turn the swivel nuts to the right to install the shifter cable.
The bushings on the end of the shifter cable crumbles and falls out. Cable can be bushed with anything that will takeup the slack. Repair both while you are in there Secure with a washer and e clip.
Loosen the shifter cable not on each end of the shifter cable. The shifter cable will come off. Reverse the process to install the new shifter cable.
The shift cable usually doesn't break. The bushings on the shifter inside the cabin have been known to break, or the clips that hold the cable to the tranny fall off allowing the cable to come off the tranny. I would check these points first before replacing the cable.
The 2002 Ford Windstar shifter cable goes from the back of the transmission to the bottom of the shifter stick. The cable is approximately 6 feet long.
How do you adjust an F-250 shifter cable? 2000 model
To change the shifter cable on a 1998 Oldsmobile Silhouette, first you need to disconnect the cable from the shifter, then disconnect it from the engine's control arm. Then replace it with the new cable and make sure it is functioning.
How long is the shifter cable on a Lincoln Town Car Exc
The shifter cable has retaining nuts on each end of the cable. Loosen the nuts. Remove the guide retainers. The cable will come off and can be replaced.