Looking for a break down (picture) for the brake housing on model 1996 TRX 300FW Honda Rancher.
http://partsfinder.onlinemicrofiche.com/cheapcycleparts/Honda_OEM/HondaMC.asp i love this site it got a brake down off ever ATV ,atc and bikes too
at the top of the lower rad hose (in housing)
turn the brake piston to adjust. adjust all the way down.
there is a problem in your brake system. take vehicle to a brake mechanic
Should be just one large bulb. You have 2 nuts to take off then the housing should come right off. after that it's just twist and pull for the bulb.
DOT 3. Listed on the top of the master cylinder cap.
If a turn signal does not blink on a 1996 Honda Accord that it is time for it to be changed. To change the bulb and locate the light housing and remove the older light. Replace the light.
pop the hood and find your brake fluid resouvier take the lid off and see if its full its that easy
It is warning you of a malfunction of in the brake system. Get it checked RIGHT AWAY!
A jack, and x-wrench, and that's about it. pull off the brake drum housing, and remove the old brake pads careful not to brake the aluminum calipers. then, do everything backwards.
I've always used at least DOT 3 so DOT 4 would be fine as well I'd imagine. If you don't feel comfortable with those you can always use the Honda brake fluid.
To replace the brake light bulb on a 1996 Ford Ranger is very simple. There are four bolts that hold the housing that will need to be removed. After the bolts are removed, the wires connector needs taken off and then the bulb can be twisted out.