Generally, you will need to cut the main water supply. This is normally in the front lawn, inside of a steel box. If you have a basement, it may be there. The main valve is square shaped and requires a tool called a water key. It is a long T shaped wrench. These can be bought at some hardware stores for $10 to $15. The other option would be to call the city Water Works. They will generally shut it off and back on, free of charge.
Yes, you certainly do.
The faucet is clogged
form_title= Bathtub Drain form_header= Fix your bathtub with help from experts. When did your drain stop working?*= _ [50] Does that bathtub drain empty water too slowly?*= () Yes () No Do you own or rent your home?*= () Own () Rent
They generally screw on. Make sure the water supply is turned off. The spout should unscrew by turning counter-clockwise. Look for screws on the plate of the faucet, or remove the center cap on the faucet (pops out) and remove the screws.
Seperate valve for outside faucet turned off, broken valve stem inside of outside faucet or handle stripped at faucet.
Turn the water off to the faucet. Remove the handle. The top of the faucet should unscrew to get to the ball valve. Replace the valve and gaskets then reassemble the faucet.
it is a tool that resurfacese the seat on a water faucet valve
Some hot/cold mixer have separate metering valves on each hot and cold water supply, perhaps the cold water supply metering valve is fully closed. Look for a slotted screw adjustment on the metering valve, using a screwdriver to open or close the valve as required.
Checks the flow of the water
mostly because of rust deposits
cold water tub facuet is corroded bye hard water builtup and needs to be replaced. Hot water is okay. Its the right one with the cold water coming out
mixing valve in a faucet: ok I will assume you are refering to a shower valve, that is the only faucet w/a mixing valve: shut off the hot and cold water. cut out valve or unsweat it. clean and flux new valve, pipe and fittings(if used) sweat in new valve