it shows you steps about what you are suppose to do on a module guide.
The Electronic Control Module (ECM) is located under the right hand side of the instrument panel.
How do you change the ignition control module in a 1988 Chevy Silverado 5.7L
check fuse/relay then if not that idle air control valve 'throttle control sensor' map sensor' electronic control module' test them all.
how do you remove the ignition control module on a 1988 ford f-250 pickup?
In a 1988 Chevy pickup the ECM is located behind the glovebox.
where is the cruise controll module relay on a 1988 linclon town car
The engine control module is bolted to the inside of the firewall in front of the glove box drawer. If you remove the glove box drawer you will be able to see it.
4.5 mm but has to be deepwell
Depending on the year. Early S10's up till 88 was located on the passenger side kick panel. The later ones are located behind the glove box.
go to www.kvitek.com/ford/.also the book ford fuel injection and electronic engine control by Charles o. probst.also i think there is one in the chiltons book covering the 1988 model year.also try questioning Google with things like 1988 eec-1v wiring schematic or printout or data.good luck.also your local ford dealer might be able to dig up one for you-service dept.
What model? This probably has electronic Climate control,therefore there isn't a Blower resistor. The blower is controlled by a Blower Motor Module...its mounted on the HVAC case under the hood near/next to the blower motor.
Behind the battery.Behind the battery.