answersLogoWhite
Spark Plugs and Wires
Pontiac Sunfire
Ford Expedition XLT
Ford Ranger XL

Where do the spark plug wires connect to the engine block on a 1997 Pontiac Sunfire 2.2 Liter?

141516

Top Answer
User Avatar
Wiki User
2015-07-17 17:54:30
2015-07-17 17:54:30

At the spark plugs.

the long part of the wire goes on the plug and the L shaped end goes on the coil pack under the intake manifold which is between the engine and the firewall,but you also have to know the firing order at the plugs and at the coil pack.

1

Related Questions

User Avatar

What causes a 1997 Pontiac sunfire gt with a 2.4 liter engine to stall when stopped at a light

User Avatar

Your 1995 Pontiac 2.3 liter engine will fit in the place of your 2.2 liter engine. The motor mounts and the wiring are exactly the same.

User Avatar

Usually right above and in line with the crankshaft pulley

User Avatar

It must have a TIMING CHAIN because Gates ( they make timing belts etc . ) does not list a timing belt for the 2.2 liter or 2.4 liter engines in a 1996 Pontiac Sunfire

User Avatar

1996 pontiac sunfire 2.2 crank was moved but cam was not could the timing get out 180 degrees before i put it back together

User Avatar

The Pontiac 2.4 liter engine, is not and interference engine. The Pontiac interference engines are all larger than 3.0 liters.

User Avatar

whaT KIND OF COOLANT DO I PUT IN MY 2001 PONTIAC SUNFIRE Generally, the GM model vehicles, or is this case, the sunfire, use a specific kind of coolant called DEX-cool extended life engine coolant. It is orange-ish in color and most of the time GM specific. i have a 01 sunfire, 2.2 liter myself, and on my car frame, i have a sticker that says "Use only DEX-cool engine coolant....". Hope this helps!

User Avatar

It is located in the front of the engine, above the oil filter, next to the starter. Your going to have to remove the starter for easier access to the sensor.

User Avatar

The engine oil capacity of a 4.9 liter Pontiac engine is five quarts. The automaker recommends using 10W-30 motor oil.

User Avatar

the 2002 Pontiac Montana came with a 3.4L engine.

User Avatar

The spark plug gap for the 2003 Pontiac Sunfire 2.2 liter 4-cylinder is .043 (in thousandths). The '03 Sunfire gets up to 25 miles per gallon in the city and 33 mph on the highway.Ê

User Avatar

The cooling system diagram for a 1996 Pontiac Sunfire can be found in its manuals. It can also be obtained as a print out at an auto part store.

User Avatar

3.8 litres from a 4.4 litre jug of 5w30.. that is for a 2.2 litre 97 Pontiac Sunfire. My boyfriend just changed the oil on my car... and this is what he figured out.

User Avatar

The Pontiac 2.2 liter engine camshaft position sensor can be found on the back of each cylinder head. The camshaft position sensor should be labeled as such.

User Avatar

No you can not puth a 3.8 liter Pontiac engine into no s10 the motor mounts are way diffrent and the pontaic is a front wheel drive

User Avatar

On a 2005 Pontiac Grand Prix : Both the 3.8 liter V6 engine and the 5.3 liter V8 engine use a timing CHAIN

User Avatar

The 1997 Pontiac Trans Am 5.7 liter engine oil pressure switch can be found on top of the engine. The oil pressure switch will be near the intake manifold.

User Avatar

i just did a engine swap in mine, i used one from a 98 sunfire gt, still the 2.4l. so any 2.4l motor from another sunfire should work, just make sure its from 1997 and up, or if you want to go to the extreme, a chevy cobalt ss motor also fits in as well,

User Avatar

I need a vacume diagram for a 1994 Pontiac sunbirb with a 2.0 liter engine


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.