electrical --( 3 )---------( 4 ) plug --------( 2 )---------( 6 ) connection ( 1 )---------( 5 ) on the coil pack
On top of the distributor at the rear of the engine ( it's the cap that has all the spark plug wires connected to it )
I believe under the distributor . It should have a plug attached to it.
There is no 2.8 Liter in a 1989 Ford Ranger. The Ranger V6is a 2.9 Liter and the distributor rotates clockwise.
I have a 1990 ford ranger,2.9L 4X4,AC. Anyways here's a link to show how it goes. http://www.therangerstation.com/tech_library/2_9_Page.html
No , the engines in a 2000 ford Ranger are E.D.I.S. ( Electronic Distributorless Ignition System )
where can you find a diagram to correct the wires from the distributor to the spark plugs on 95 ford e250?
where is the fusible link on a 1996 ford ranger xlt
To replace the brake light bulb on a 1996 Ford Ranger is very simple. There are four bolts that hold the housing that will need to be removed. After the bolts are removed, the wires connector needs taken off and then the bulb can be twisted out.
( # 17 ) is a 15 amp fuse for the cigarette lighter in a 1996 Ford Ranger
where is the shift solenoid on a 1996 ford ranger 4x4 with a 4.0 v6
1996 ranger does not have speedo cable it is electronic
The distributor is at the back of the engine . I was looking at a picture of the Ford 2.9 L , but all I could see was the spark plug wires on each side of the engine leading to the distributor because it looked like the upper portion of the intake manifold extended over top of the distributor. (Helpfull)