How do I add a picture as this will show exactly where to fill with hyraulic oil, its a round silver/gold cap held in place with a single wing nut between the radiator and the engine.
My 1977 CJ5 with a 304 has power steering.
Power steering pump is located under the alternator on the driverside. Best way is to remove the alternator and add to the cold line. It is a pain, there is no really easy way.
Power assist steering and Power Steering are the same thing, just difrent names from difrent Manufacturers.
Ideally, use a transmission flush machine. Failing that, disconnect the return hose, then run the engine and steer back and forth until you can't do so (with the front wheels off the ground.) Repeat three times. This is more complete that a power steering flush from most chain service outfits. I recommending using Dexron instead of "power steering fluid" for this vehicle. The better detergent additives and higher compressibility can keep the system going for a longer time. If, however, you've just recently (less than 6 months) replaced both the pump and the gearbox, you might be better off using Honda-compatible power steering fluid.
any gear oil
Mercedes Giallorenzi was born on November 7, 1977, in Argentina.
The spark plug gap for your Mercedes is .032
the small round cover on the p/s pump has a small stick attached to it
Of course...
Hi my name is Ali mercedes-benz 1977 left-hand drive please you are Explain firing oder thanks
all Fords prior to 1977 used type F. Update: Type FA. Unfortunately, Type FA is very difficult to find, and I think Valvoline is the only maker now. Most folks nowadays use Type F for their old T-Birds. Some use Mercon. Either way, if you're unsure which type of fluid may be in your '64, I would suggest draining the transmission fluid and using Type F. Drain the the converter as well. If your transmission has recently been rebuilt, you can use Mercon. Note: The power steering for this vehicle is designed for Type A Transmission fluid as well. Using regular power steering fluid or a synthetic fluid will usually cause leaks as these fluids are too thin.
Dot-3 fluid