Bonjour,je recherche un rack (tray)pour un Chevrolet chevy van 20 , 1983.
Adersse E-mail : belangerlaurent@videotron.ca
The clutch bleed valve on a 2.2 liter Chevy Ecotec engine is located on the slave cylinder. To find the slave cylinder remove the battery, as it is mounted underneath the battery tray.
I believe that is located below the battery tray
library
You will find the outside air temperature sensor under the battery tray
Disconnect the battery cables on the Wrangler. Find the battery hold down and depending on the style, either loosen or remove it. Lift the old battery out. Set the new battery into the battery tray. Reinstall the clamp, then connect the battery cables.
I THINK the horn is mounted below the battery tray
You can find a fuse box diagram for your 1983 Chevy Camaro in the back of the owners manual. You can also find the fuse box diagram in Chevrolet service manuals at your local library.
under the batter box. remove the battery the tray and you will find it under there
1988 chevy cavalier flasher take ash tray and bracket out look up and lift you can see it if not you can put your hand up in to lift and find it.
I haven't seen one on a '98 Jimmy, but I have a '96 Jimmy and they are probably the same. It is circular, about 3 to 3 and 1/2 inches in diameter and about 1 and 1/2 inches thick. In order to get to it, you have to remove the battery and then remove the battery tray. You will find the actuator hiding underneath the battery tray. Best of luck, Paul H.
If you take out the battery tray and turn it over, you will find the Battery Temperature Sensor. Just found out this was the reason my check engine light stayed on. One of the wires was exposed and discharging to the frame of the jeep.
I doubt it but I am not 100% sure. It is unlikely in 1983 BMW was using a positive ground system. You can easily find out. Trace the negative battery cable and see where it goes. It is is attached to ground then it is a negative ground system.