Want this question answered?
You don't as that is far too dangerous. Drop the fuel tank to remove the pump.
its a 02 sensor it measures the oxygen coming out of your engine
Find the alternator, under the hood on the passenger side. Now look toward the firewall, and about a foot down from the alternator, you'll see two 2 inch pipes going into the firewall, one has a blue dust-cap on it, it's kinda difficult to reach, but if you have skinny arms you'll be able to just reach it and twist off the cap... the cap will have a 1/8'' hole in the top and a large letter L next to the hole. I hope that helps
Your question is incomplete. You asked a question that is like, "Where is the hole in the Swiss cheese?". There are usually several holes and each hole has a specific item or loom of items running through it. For example, the speedometer cable may have a hole in the firewall for itself or the A/C lines have holes in the firewall for their passage. BETTER QUESTION: WHERE IS THE HOLE IN THE FIREWALL FOR THE _________________?
Your question is incomplete. You asked a question that is like, "Where is the hole in the Swiss cheese?". There are usually several holes and each hole has a specific item or loom of items running through it. For example, the speedometer cable may have a hole in the firewall for itself or the A/C lines have holes in the firewall for their passage. BETTER QUESTION: WHERE IS THE HOLE IN THE FIREWALL FOR THE _________________?
There are several firewall holes.The firewall is the wall that divides the engine from the passanger compartment.Under the windshield.
It is located on the rear of the motor, under the exhaust manifold. Be careful when taking it out, they have been known to break off in the hole, and then become a real pain to finish the repair..
i have a 01 ls and my battery is in the trunk right next to the spare tire
it will fit but you will need to drill out an ignition switch hole unless you also transfer over the 69 steering column.
If you cant find an openening large enough then you can always drill a hole and place a grommet in the hole and then run the wire through the grommet. Hope this helps.
There should be a location where you can go through the firewall where other wires are already there. Piggy back on that hole. If not then just drill a hole through the firewall, being very careful not to drill into any wiring or components. Insert a rubber grommet in the hole to protect the wire, and then the wire.
there is a little hole right under the hood next to the driver side door