0
Where do you find a schematic to reassemble a western field shotgun trigger assembly model 550a?
Wiki User
∙ 13y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Does anybody know If there is a release trigger assembly for the Remington 870 shotgun?
The 870 Remington shotgun used to be a popular candidate for a "release" trigger.
You are trying to reassemble your American Double Action replacing the broken trigger spring It is a five shot drop cylinder in 44bulldog Does anyone have tear down instructions or schematic?
You need a gunsmith
How do you re install trigger assembly in Remington 1100 20 gauge shotgun?
Best to ask a gunsmith for help.
How do you remove the magazine spring from a Sportsman 58 Remington shotgun?
Unscrew the end cap on the stock fore-end. slide out the barrel. slide off the fore arm. punch out the two pins holding the trigger assembly. slide out the trigger assembly. remove the charging handle by pulling out as it is only held by a detent spring and ball. push in on the end of the tube opposite the stock end until the detent on the rails matches up to the small cutout on the tube. pull up on the rail and that releases the gas tube assembly and spring. press in on the spring plate that the bolt assembly runs into as your sliding it out of the receiver and the bolt and rail assembly will slide out. clean and reassemble. No lube in the gas tube area.
How do you use a shotgun?
Pull the trigger
Which cycle begins by pulling the trigger of a shotgun rearward?
Depends on the shotgun.
How do you breakdown a Stevens 940a shotgun?
pull forearm off. open barrel and remove. drift 2 trigger assembly pins out. pull trigger ass. down and out. now drift the barrel catch pin and the lever and catch can be removed.
How do you replace a trigger on a 1984 50hp outboard motor?
To replace the trigger assembly on the 50 hp Mercury outboard, the flywheel and the stator assembly must first be removed. Next, remove the link rod from the timing advance arm and remove the trigger wires from the switchbox. Take note of how the trigger wires are routed to aid in installation of the new trigger. Now the trigger can be lifted out of the top end cap. While noting the number of turns, screw the link arm out of the old trigger, and remove the retainer nut. Install the retainer nut into the new trigger, screw in the link rod, and slide back into the end cap. Reassemble in reverse order.
How do you reassemble a trigger on a braztech 20 gauge?
You need a gunsmith, and not WikiAnswers for this one. Sorry-
How do you oil a Tippmann A5?
First you want to remove the barrel, tank and hopper. then you need to take out the pins and slide out the rear assembly, as well as disconnecting the tombstone and the trigger assembly. Then you need to put a small amount of oil on all of the o rings, clean out any paint or grease, then reassemble it.
Where is the safety on a 520 shotgun?
It is a lever inside the trigger guard, forward of the trigger.
How do you reassemble the trigger mechanism on a air-arms jackal?
See the link below. It may help you.
