You would pour it in the radiator. Caution, stop leaks usually clogs heater cores.
take off old starter and install new one in its place. finished
To remove the clutch fan on a 1993 Mercury grand marquis hold the fan in place using a clutch fan tool, then remove the holding nut. Most large auto parts chains will loan you the tool.
The 1992 Mercury Grand Marquis dashboard is held in place with six retaining bolts and 14 retaining clips. Remove the retaining bolts and pry outward on each retaining clip. The dashboard will come off in two pieces.
I just had a throttle position sensor installed in my 1999 mercury grand marquis. I feel certain it is located in the same place on your 1998. Look up top behind the air intake tube (large hose) leading to your throttle body. It is a rather small black hard plastic item. www.autoclinix.com is a good website for printing out the directions for installing all parts on your mercury grand marquis. Good Luck, Ms. Lena
Replacing the thermostat on a 1996 Grand Marquis is not very hard. First, follow the upper radiator hose to find the thermostat. Then disconnect the hose and drain it. After the hose is drained, remove the bolts holing the thermostat housing in place. Take the old thermostat out and replace with a new one.
Special tools are required to hold the cams in place while you assemble chains and tighten sprockets. Consult a shop manual for exact procedure.
Removing door panels from cars is pretty easy. A person needs to find and unscrew all of the screw holding the door panel in place.
Changing a radiator in a 1997 Pontiac Grand Am can be a difficult task. To remove the radiator, all of the radiator hoses will need to be disconnected from the radiator. The transmission lines will also need to be removed. After all of the hoses are disconnected, remove all of the clips that are holding the radiator in place. Lift the radiator up and place with a new one. All the hoses and clips will need to be put back in place with the new radiator.
Should be self-adjusting unless tensioner is bad get a tensionier bar from the auto store. Place it the hole or around the nut moves the tensioner, either up or down.
GO to eBay > eBay Motors > place search : For "2004 mercury Grand Marquis Lighting Control Module" , Bunch of listings show up , choose the Lighting Control Module picture that is in WHITE NEW BOX , full instruction ,Where is located ?, step by step removal instruction is all there. The company is ELECTRONICS REMANUFACTURING SERVICE.
there is no radiator cap. it is a sealed system meaning the only place to fill and check is thru the overflow resevoir.
Remove the entire dash. It is buried into the bulkhead (also called firewall). Ford, Chevrolet, and Chrysler has been locating them in the same place for nearly 100 years and it has always been the same procedure to change.