The 1994 Ford Probe has a brake fluid reservoir that should be mounted on the drivers side firewall. Remove the cap on top to add fluid.
if you can see the dipstick you put it in there if not there will be a tank in the engine
You check it and add fluid at the same place. Look on the transmission for a dipstick.
You can put a carburetor on any motor.
put it in
NO you can't because a ford probe Gt is a v6 while the ford probe base is a flat 4. Because of this the car is shaped differently including the bumper so you need to order a bumper for a base ford probe. this guy is wrong it is a direct bolt on and its inline 4 not flat 4
take out the old on and put in the new one
The brake fluid in a 1992 Ford Escort gets put in the brake fluid reservoir. This is normally located on the master cylinder.
Directly into the carburetor throat (remove air cleaner).
it will free a stuck valve
To put brake fluid in a 1997 Ford Explorer, you must locate the brake fluid reservoir. Once you locate it, unscrew the cap, and replenish the brake fluid.
On a 2006 Ford Escape : The brake fluid reservoir is also the clutch fluid reservoir
Transmission could be adversly effected. Shifting problems can occur and worse case the transmission can be permantly damaged.
where to put transmission fluid at in 93 ford areo star
were do you put the hydraulic fluid in 2000 ford tractor
The brake fluid reservoir
Clutches in laser are operated by cable you don't have to put fluid anywhere.
you put the brake fluid inside the master cylinder
why would you want too
put it in hot water :)
According to the manual, 7.9 quarts.
Negative......V6 uses different trans than I4
You add the fluid in the same place you check it. Where that is, your owners manual will describe. Down below, behind the air filter. Little dipstick with black rubber handle. Need a funnel to fill. -CE
Unless it has a sealed for life transmission, you put fluid down the dipstick, where you check the fluid level.