answersLogoWhite

0


Best Answer

you must remove the spedometer cable from the transaxle/ fill through here

User Avatar

Wiki User

โˆ™ 2007-04-04 18:17:57
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: Where do you put tranny fluid in 1989 Mazada 626?
Write your answer...
Submit
Related questions

Where is the brake fluid reservoir in a 1989 Mazda 626?

The brake fluid reservoir on a 1989 Mazda 626 is on the master cylinder. This is located in the engine compartment on the drivers side.


Why is it that my 99 mazada 626 keep jumping time?

Because its not really a Mazda 626... Its a Delorian... ..


Changing the front brakes on a 1997 mazada 626 do i have to pull the entire caliper off?

you have to unbolt the caliper off the rotor, but not from the brake fluid line.


How much is it to replace a crank sensor?

How much will it cost to replace a cank sensor on a Mazada 626?


Where is the reserve tank for the clutch fuel in 99 mazada 626?

I'm not positive about the '99 model year, but the hydraulic clutch shares the fluid reservoir with the brake system in earlier Mazda models.


Where do you add the transmission fluid in a 1989 Mazda 626?

I assume it is a stick-shift? The transmission will have a plug located on the side, where you can add fluid, if needed.


How do you fix a stuck seatbelt passenger side mazada 626?

Once a seatbelt starts sticking its gonzo and needs to be replaced.


Bell time need el diagram mazada 96?

hi need el diagram Mazda 96 626


How do you change transmission fluid on 1995 Mazda 626?

How to check the transmission fluid in a 1995 Mazda 626


Where is transmission pan on 1997 Mazda 626?

Should be on bottom of tranny.


Where would you find a diagram for a catalytic converter Mazda 626?

Where could I find diagram for 2003 catalytic converter on a Mazada 6


Where can you find a radio wiring diagram for a 1989 Mazda 626?

My 1991 Mazda 626 will start and idle fine but when you put it in gear the HOLD light flashes and the car will not move almost as if the tranny is shot but its NOT the flashing hold light indicates that there is an electrical problem with the tranny but my question is is there some kind of reocuring problem with this year and model if so how do i fix it


Can you swap a 94 Mazda 626 tranny with a 96 Mazda tranny?

No you cannot swap a 94 into a 96 626 and vice versa. But you can use a 96 Ford Probe transmission in a 94 626. Check www.car-part.com for a list of transmissionsin your area. The listing will show alternative vehicles that the same tranny came in. I use it all the time when hunting compatible parts.


Where is the brake fluid reservoir on a Mazda 626?

The reservoir is located on the master cylinder in a Mazda 626. To add fluid, simply remove the reservoir cap and pour fluid in.


1998 Mazda 626 4 cylinder transmission filter location?

drain transmiision fluid from transmission, remove bottom oil pan from tranny, and you will see filter there is no pan on bottom of transmission do anyone have the answer?!


Spark plug gap for 1989 Mazda 626?

1989 Mazda 626 2.2L FI 4cylThe Spark Plug Gap.044 (In thousandths of an inch)


How do you disconnect drive shafts on a 1989 Mazda 626?

See the Related Links for "mazda 626 forum" to the bottom for the answer.


What type of transmission fluid is used in the 1992 Mazda 626?

Best place to look for vehicle fluid specs. is at www.amsoil.com. Click on their "online application guide", follow through with your make-year-model. Of course they will recommend their product, which is excellent, but I have found that that year and range of Mazda 626's require "Dexron II". Use a "synthetic" version when possible and you will run cooler and your tranny will hold up better!


Where is the washer fluid pump on a Mazda 626?

most washer fluid pumps are on the resivour itself


Why would the OD Off light be blinking while the check engine light is on in 1996 Mazda 626 Dx Sedan?

Commonly, the OD blinking and subsequent CEL are due to the tranny overheating. Most common on the 4 cylinder (AT) models. OD light blinking implies the tranny is overheating. the CEL appears when the tranny is significantly overheating. Frequent fluid changes and an auxillary tranny cooler can help extend the life. It appears that the transmission on the 4 cylinder is simply undersized.


How many quarts of transmission fluid in a 1990 Mazda 626?

Best place to look for vehicle fluid specs. is at www.amsoil.com. Click on their "online application guide", follow through with your make-year-model. Of course they will recommend their product, which is excellent, but I have found that that year and range of Mazda 626's require "Dexron II". Use a "synthetic" version when possible and you will run cooler and your tranny will hold up better! Best place to look for vehicle fluid specs. is at www.amsoil.com. Click on their "online application guide", follow through with your make-year-model. Of course they will recommend their product, which is excellent, but I have found that that year and range of Mazda 626's require "Dexron II". Use a "synthetic" version when possible and you will run cooler and your tranny will hold up better!


What trans fluid for 2002 Mazda 626?

Dextron III or IV


Can a 1989 Ford Probe tranny fit 1993 Ford Probe tranny?

noAnswerno the only years that will work are 93 to 94 ford probe, 93 to 94 Mazda 626, and 93 to 94 Mazda M6 and if its a (CD4E) Transmission good luck you will need it! Answerthe tranny form a 93-95 should work i swaped my auto out to a 5 speed from a 95 and my car is a 93 works fine few extra parts left over


What type of brake fluid does a 1995 Mazda 626 DX use?

DOT3


Where do you put transmission fluid in a 2002 Mazda 626?

down the dipstick tube