0
The actual gauge involves pulling parts of the dash and the instrument cluster. At that point it is a simple matter of plug it in and put it back together. If the float in the tank need replacement you'll have to drain the gas tank and take it out that way. Haynes auto repair manuals have great references for more precise steps.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you replace a fuel gauge sensor in a 1993 Saturn?
the fuel guage in my 1993 Saturn goes wiggling back and forth. how do i fix this problem?
Where is the fuel filter on a 1993 Isuzu Trooper 43k?
underneath the gas pump in a 1993 trooper.
How do you fix a fuel gauge on a seadoo spx?
Take out the fuel gauge and fish for the magnet inside the fuel tank. Then disassemble the fuel gauge to replace the broken magnet. Reassemble and replace. Done...
How do you replace fuel injectors on 99 trooper?
99 isuzu trooper smell gasoline in the engine compartment
What is the PSI of a fuel pump for the 1993 Isuzu Trooper?
43 psi
How do you fix a malfunctioning fuel gauge on a 1993 Ford Explorer?
Usually the fuel level sensor in the fuel pump. ANSWER A 1993 Ford Explorer also has a 15 amp fuse in location # 17 for the fuel gauge
How do you replace the fuel pump in a 1993 Ford Bronco?
how do I replace a fuel pump on a 1993 Ford Bronco 302 5.0 L
Why does the fuel gauge read past full after replacing the sending unit in the fuel tank and the fuel gauge in my 1993 Chevy pick up?
possible bad ground
1993 Honda accord fuel gauge stuck in high?
Change your fuel sending unit.
What color is the wire for the fuel gauge on a 1993 Ford Ranger?
Grey
How do you fix a fuel gauge on a 2004 silhouette van?
Most fuel gauge problems are caused by a faulty fuel gauge sending unit. The fuel gauge sending unit is located inside the fuel tank. In most cases the fuel tank must be removed to replace the sending unit.
How do you replace the fuel gauge in a 2002 subaru wrx?
Remove the instrument panel cover from your 2002 Subaru. Remove the fuel gauge retaining screws. Remove the wiring harness from the back of the fuel gauge. Reverse the process to install your new fuel gauge.
