answersLogoWhite

0


Best Answer

possible bad ground

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why does the fuel gauge read past full after replacing the sending unit in the fuel tank and the fuel gauge in my 1993 Chevy pick up?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

1993 Chevy heat gauge want work?

1993 chevy 4.3 v6 1500 truck temp gauge inoperative,


What can you check after replacing the fuel gauge in a 1993 ford tempo it goes to the full mark and stays there even if the tank is almost empty?

Fuel tank sending unit. Fuse.


Temperature gauge does not work on a 1993 Camero Z28 why?

Bad gauge, bad sending unit, bad wiring.


Why would a gas gauge stop working on a 1993 Chevy Silverado truck after the fuel pump was replaced?

Chevy's are known for this problem, i just recently had the same problem and what you need to do is replace the fuel sending unit. My original problem had to do with my fuel pump not working and i wasn't really worried about the gauge but we figured since we had the tank down we might as well swap the sending unit and my gauge starting working. Good luck


What runs the temperature gauge in a 1993 Dodge Intrepid Gauge not working but fan is and check engine light is on.?

try replacing the thermostat


How do you change a oil sending unit on a 1993 Chevy 57 truck?

HUH???????????????????????????


1993 Honda accord fuel gauge stuck in high?

Change your fuel sending unit.


How do you Replace head gasket Chevy Suburban?

what is the preceger for replacing the head gaskets on a 1993 chevy suburban 4x4 350


What causes the temperature gauge to quit working on 1993 Chevy Corsica?

bad temp sender usually. Bad gauge rarely.


If you changed a motor from a 1993 Chevy S10 to a 1984 Chevy S10 and everything is working properly except the oil pressure gauge which pegs at 80 psi when the ignition is turned to run how do you find the problem?

Hey William==This means that the gauge on the dash isn't getting a signal from the sending unit. The sender is either not plugged in or there is a break in the wire somewhere. GoodluckJoe


Why doesn't the temperature hand work on a 1993 Chevrolet Caprice?

Ground the wire that goes to the temperature sending unit and if the gauge goes up then the sending unit is defective.


1993 ford f-250 gas gauge not working?

fuel gage sending unit inside the fuel tank