Door Code Location...I actually found the door code behind the fuse box area (Driver Side) on my brother's 2000 Ford Expedition EB. There is a big white sticker with 5 numbers starting with number 1####. Hope this helps...
Door Code Location... I actually found the door code behind the fuse box area (Driver Side) on my brother's 2000 Ford Expedition EB. There is a big white sticker with 5 numbers starting with number 1####. Hope this helps...
You can't miss it, it is located on the exterior of the driver's-side door just below the window.
Then you have the wrong code...that can happen if you buy a pre-owned Trac and the previous owner personalizes the code. You can reset your factory set code, directions are in your owner's manual.
The keypad code for your vehicle is specific to your vehicle and your vehicle only. A Ford dealer can reprogram the code if you do not know it.
A default password would be a huge liability for Ford. Contact your dealer, as they may be able to locate the factory code on the computer.
Door Code Location...I actually found the door code behind the fuse box area (Driver Side) on my brother's 2000 Ford Expedition EB. There is a big white sticker with 5 numbers starting with number 1####. Hope this helps...
It could be any of 100,000 combinations.
there's a sticker on the trunk lid with the code on it
Door Code Location...I actually found the door code behind the fuse box area (Driver Side) on my brother's 2000 Ford Expedition EB. There is a big white sticker with 5 numbers starting with number 1####. Hope this helps...
Door Code Location... I actually found the door code behind the fuse box area (Driver Side) on my brother's 2000 Ford Expedition EB. There is a big white sticker with 5 numbers starting with number 1####. Hope this helps...
# Enter the permanent factory remote keyless entry (RKE) keypad code. # Press the 1/2 button within 5 seconds to activate the programming mode. Holding the 1/2 button for more than 2 seconds after activation erases the stored customer code. The door locks lock, then unlock, confirming the code is erased. The existing code does not need to be erased to program a new code. # Within 5 seconds , enter the new 5-digit RKE keypad code. The door locks lock and unlock to confirm the new code is programmed.