0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Replace the ecm on 91 cutlass ciera?
The ECM is located behind the glovebox on a 1991 Cutlass Ciera. Pull the glove box out to see it. Once located remove the mounting hardware and unplug it from the car. Replace the unit.
Where is the map sensor on 90 olds cutlass ciera?
Where is the choke sensor on a 1991 Oldsmobile ciera 3.3L
How do you change a battery for a 1991 cutlass ciera?
the way your mom gets on her knee
Where is the cooling fan relay located in 1991 Oldsmobile cutlass ciera?
The 1991 Oldsmobile Cutlass cooling fan relay switch can be found attached to the right side of the radiator housing. The cooling fan relay switch should be labeled as such.
Where is the pcv valve located on a 1991 Oldsmobile cutlass supreme?
its in back valve cover at fire wall i removed the plenum from the intake manifold to get at it.
That is the trouble shooting codes for a 1991 Oldsmobile cutlass ciera?
my car turn over,but will nostart.
Where is the crank sensor on 1991 olds cutlass ciera?
the crank sensor is behind the harmonic balancer
How can you tell if the quad drivers are bad in a 1991 Oldsmobile Cutlass Ciera S?
Need to know what quad drivers are...
How do you adjust the reclining part of the front seats of a 1991 Oldsmobile Cutlass Ciera S?
Are they power seats in the front? My 1993 Ciera S has power recline - each switch is located at the front corner of the seat (near the door on the seat itself). Good luck!
Where can you find a replacement keyless remote for a 1991 Oldsmobile cutlass ciera?
This probably has to be ordered from the dealership as it needs to be encoded, which is proprietary information.
Where do you find the paint code for a 1991 Oldsmobile Cutlass Ciera?
Look under hood against firewall - should be a plate with paint codes
Why would a 1991 olds cutlass ciera not start after engine gets hot until the engine has cooled off a bit?
I have a 92 cutlass ciera doing that, would run til it got hot, then die...ended up being the crank shaft sensor. hope this helps
